Normal is fine.

Tail lamps that are always on are consumable.
Stop-lamps are still alive but replaced immediately when noticed to avoid maintenance failure due to trivial things.
We had thought about using LEDs, but we concluded that Standard was the best choice due to its cost performance and reliability.
In the case of DJEBEL, the OEM installed Carrier interferes with the approach of the Tail lamp cover to the Screw. This is where SEA BASS comes in:remove the rear screws from the carrier, loosen the front screws, and stand the carrier up like a Gal wing, and the replacement can be completed in a few minutes.
The durability of the bulbs is a matter of luck, but since it is a product of FOR JAPAN MODEL MANUFACTURER, it is safe to use for the time being. View detail

Tail lamp replacement for JOG for repair.

Tail lamp bulb of a 2-stroke JOG obtained through a private sale was broken and was replaced.

Lower price than Valve for OEM Parts, Quantity:1 Set of 2pcs.
I will only use 1 pc. and will keep the other one as a spare.
I thought about using LED Tail lamp bulbs, but since it is a 50cc moped, these are sufficient.
*Wattage should be matched to the OEM. View detail

It is safer to always have it at home with Spare!

The cheap Pine Stripe bulbs, but just one of these can cause a maintenance failure!
They run out without notice, so it's always safer to have one in reserve.
Depending on the model of car, the replacement work is a single +Driver. View detail

No problem and safe. Just be very careful about the angle and shape of the mouth Gold.

For the Tail lamp, we avoided LEDs so that the power generated would be used properly in combination with the power consumed.
I hear that it is not good to have too much surplus electricity because once electricity is generated, it can only be converted into heat, etc. at the Regulator.
The Headlight is always on and off and I thought it would not be affected by the LED, but the Tail is always on, so I left the White hot bulbs on.

Made by Pine Stripe, no question about it...White heat bulbs are becoming a component that I'm thankful they still manufacture.

We kept one as a spare just in case. View detail

it is normal

Product Name
M&H Pine Stripe MAnd H Pine Stripe Double Base Bulb S25 BAY15D

Item Number
1P3407C

Vehicles
DREAM110

Number of man-hours
Around 5 minutes

Why did you choose this product?
I bought this as a for repair because my Tail lamp was out.
The reason why I chose it is that it is inexpensive, which is a Large reason.
I decided to use regular bulbs because it was not worth it to replace them so many times when I changed to LEDs.

Impressions after using it
You can definitely use it and it will light up if the Size compatibility with the vehicle is not wrong.
If it does not light up, it is likely that you bought the wrong product or the product Body is defective.

The product I bought worked fine for both the tail light and Brake light, so the vehicle was repaired without any problems.

▼ Attention
Size and Type vary from vehicle to vehicle, so you need to research before you buy. View detail

Stable M&H.

I have no complaints about the quality and price. View detail

I'm doing my job reasonably well.

I bought this because my stop light bulb was out. Replacement was very easy and only required a Phillips head screwdriver. I have no complaints if it is durable. View detail

Reliability Large for a quick fix

I bought it to repair the Tail lamp of the commuter car which had been cut before I knew it. I thought about LED for a moment, but when I think about the reliability of the cost and delivery time, the large thing is that it arrives sooner than anything else and can be fixed quickly.
It's a bit pathetic that if you buy two balls, one is out of stock, but the product is reliable. View detail

Eggplant-type Valve

Used for Blinker.
It is a slightly fat eggplant shaped Valve. No problems in use.

Around Amazon, Valve which converts Socket to LED is sold as it is, but honestly there is no sense of security at all, so I will continue to use this kind of conservative White heat Filament in the future. View detail

Purchased as Spare

Because the price is affordable, I bought it as a reserve. It is easy to understand if there is a conformance table, but it is not fun. It is supposed to be no problem because it is decided by standards - - - View detail

To LensSmoke

Purchased to Customize Blinker lens to Smoke. Because it is a Position lamp at Front, I could not find the Double Bulb very easily, finally found it here and it was saved. The rest is durable, but the thing is Stripe pine, so I am not too worried. View detail

Speaking of light bulbs

Purchased because Tail lamp was out of order.
Although I feel a little disappointed to order for only a light bulb, this time I bought other items as we planned to purchase other items.
Because the price is also cheap, I think that it may be purchased as a spare before it expires. View detail

Sense of security domestic after all is charm. I think that durability is also high.

Sense of security domestic after all is charm. I think that durability is also high. View detail