Reviews
as insurance
No problems with quality and installation.
The Slider became the support against the ground firmly, and Cowl etc. of the upper part of the body were unharmed though I accidentally did a standing fall on a slope.
I'm sure the results would be different if the speed was higher, but I think it does its job well.
View detail
High sense of quality and rigidity
The engine mounting bolt is removed and installed, but there is no need to support the engine. You don't need to support the engine.
The color is Black, but I think it is SMART and I personally don't feel uncomfortable with the body color.
The bracket part is also very rigid and has the right amount of lateral overhang.
Maybe there is no Damage on the Bracket part by the impact of a standing fall.
However, it is only a Slider, not an Engine Guard, so don't expect any more Guard functions than that.
I believe the Slider is intended to glide over the body of the vehicle in the event of a fall and prevent injuries where the Rider is caught in the body of the vehicle. The price is relatively low and it looks SMART.
Depending on the material and road conditions, the Engine Guard will also glide reasonably well. The price is relatively expensive, and the appearance also changes like Large.
The guards and sliders sticking out horizontally on the underside of the vehicle will cause the tire to float when the vehicle falls over, causing large damage to the upper part of the vehicle such as the handlebar and tank.
In the case of the VTR, when it falls, the RearSide cowl, footpeg, Handlebar End, and Lever will take the main damage, and if you are unlucky, the Headlight and Meter area will be hit hard.
View detail
Hmm, well, that's about it …
I bought the antlionMounting Slider at We-Big in 2013 for the first time in years It's been a long, long way to this point, and it's been a hell of a ride
I simply couldn't install it using the DESSERTExhaust System Up Type Since the Down Type Exhaust System was replaced, it was possible to put it on Yes
Installation itself is easy, but you need a tool with a slightly longer neck, such as semiLong ratchetetc I can't install it properly. 14mm semi-long or longer seems to be two pieces of wood, so be careful You can buy long tools for a few hundred yen if you're not picky
Because it doubles as an engine mount with plus alpha, use screw lock agent It's about 200 yen for a small type
The appearance is as shown in the image, and we won't know how effective it is until it's mossy, but the Engine and Wouldn't it be a good buy if Tank could protect it?
DoAsInfinity~!
View detail
Fits: KAWASAKI ZZR1400 (ZX-14), KAWASAKI ZZR1400 (ZX-14)
Cospar good
It's easy to install and solid
I don't know how well I can protect Cowl as I haven't beaten him yet
But it's best not to use it!
View detail
It is not moss yet - -
I was wearing Engine Guard.
Although I was slightly surprised at Large
I feel comfortable when I try to install it.
Installation was easy..
It is not moss yet, but it seems to keep firmly around the engine !!
View detail
Individual difference? Is it a mistake of conformity check?
Purchase a car type setting as insurance when falling down here.
Because it is Brand which passed by name, making is perfect.
However, is it an individual difference of a vehicle? Since Oru line from FrameOil tank interfereed with Color and could not be attached, we cut a little with Belt sander.
Since it is an instruction to install at the position of the image in the Instruction Manual, I thought about the strength and thought it was not attached to the Frame side, but Air tooletc. If I do not have it, I think cutting work is Large strange.
Also, at this position, will you oppress the Oil line when the Slider bends when falling? It's a bit uneasy.
If you are told if you can recommend it "Neither" Is my opinion.
View detail
Fits: KAWASAKI D-TRACKER [D-Tracker]., SUZUKI 250SB, KAWASAKI D-TRACKER [D-Tracker]., SUZUKI 250SB
It is Large young than I thought
Installation was easy, but I am worried that WaterLine will be forced to somewhat forcibly mount and that the water flow will be unimpeded.
As a thing, Slider part and Mount are beautiful, and Bolt of installation is also plating well, I think that quality is high. When it kills, it seems that Engine will protect it exactly, so it is recommended to put it in preparation for standing.
View detail
Fits: KAWASAKI D-TRACKER [D-Tracker]., SUZUKI 250SB, KAWASAKI D-TRACKER [D-Tracker]., SUZUKI 250SB
The product is made firmly.Since it interfered with the Oil catch tank made from , however K&T, what must give up either was regrettable.
The product is made firmly.Since it interfered with the Oil catch tank made from
, however K&T, what must give up either was regrettable.
View detail
It took two months, after placing an order before arriving at hand. since -- it is *4 piece. The attached touch is quite good also at .
It took two months, after placing an order before arriving at hand.
since -- it is *4 piece.
The attached touch is quite good also at
.
View detail
[ -- the Webike Monitor ] -- attachment of this product is the 2nd time. Since an attached part got damaged by the fall last time [ ], it is exchange. Since it was the one Frame support, distortion of a Frame was anxious on the vehicles tar
[ -- the Webike Monitor ]
-- attachment of this product is the 2nd time.
Since an attached part got damaged by the fall last time [
], it is exchange.
Since it was the one
Frame support, distortion of a Frame was anxious on the vehicles target with weight, but two flat knots have been found [ a great problem ] and purchased in comfort probably because of the thickness of a Shaft.
Although he does not want to already fall, I think it beautiful to make No. 1 in the same price range.
View detail
Although the engine performance is not known yet, having chosen the White color answers correctly. dirt is an One-point Accent to a Motorcycle, although it grows into mind.
Although the engine performance is not known yet, having chosen the White color answers correctly.
dirt is an One-point Accent to a Motorcycle, although it grows into mind.
View detail
It falls with some slip down at about 50 km/h on right-hand side on a rainy intense day. It was meaningful although I contributed before the impression of the contents of being almost meaningless about this mount slider! If it is original, the slider
It falls with some slip down at about 50 km/h on right-hand side on a rainy intense day.
It was meaningful although I contributed before the impression of the contents of being almost meaningless about this mount slider! If it is original, the slider which must be a step, a brake pedal, and parallel has turned to those for the wrong directions with the impact of the fall.
The powder with a white slider which was able to be shaved per Kami, a tycoon's case guard, had scattered.
However, since a little [ that the slider was actually able to be deleted / merely ], when reinforcement was high, he felt actually.
If this slider did not exist, possibly the step and brake pedal which are inside had hit with the ground surface directly, and since that one was considered to become large, although damage thought that it was useless, it had attached, and was good. [ of that one ]
:D which can be used again, and is likely to be simply fixable since that is right if the crooked bolt is exchanged
View detail
It attached as look before you leap. It is not dissatisfied in a price, quality, etc. However, since a by no means deep angle of bank becomes still severer even when it is normal, special attention is required.
It attached as look before you leap.
It is not dissatisfied in a price, quality, etc.
However, since a by no means deep angle of bank becomes still severer even when it is normal, special attention is required.
View detail
This slider is attached to GSX1400. First, depending on a view, a price is also stretched very well in Ho who is examining whether a mount slider will be attached, and it is not good-looking, and, and yet, is a degree of an effect... Is it a plug now
This slider is attached to GSX1400.
First, depending on a view, a price is also stretched very well in Ho who is examining whether a mount slider will be attached, and it is not good-looking, and, and yet, is a degree of an effect... Is it a plug now [ direction ] which is considered to be ??? It is the impression based on real experience from me to such a direction.
The other day, it fell also with the misfortune.
However, since this slider was attached, damage remained in the minimum.
Although I attach white, I match the coloring of GSX1400 K7 very much, and think that it is individual with it being Good.
And since it was preeminent also for the effect, we recommend you to attach a sake [ when a slider is emergency ] (direction currently examined).
View detail
When he thought that he would attach a hand guard and would also attach the mount slider here, since Ho's evaluation attached to the vehicle type by the impression here was low, it wavered considerably, but it purchased as a cane of the point which fell o
When he thought that he would attach a hand guard and would also attach the mount slider here, since Ho's evaluation attached to the vehicle type by the impression here was low, it wavered considerably, but it purchased as a cane of the point which fell over.
Although only the comment from the seen touch can be said since it actually falls and has not pushed down ...
I am feeling that it is better to protrude outside about 5 more cm for both sides.
Structure of a product is solid.
When a point fall is carried out, there is no telling what kind of result bring, but I want you to sell for about 5000 yen at least.
View detail
Fits: KAWASAKI ZZR1400 (ZX-14), KAWASAKI ZZR1400 (ZX-14)
It was able to stand, although attached also to the vehicles which were before, and the crack of GOKE was able to be kept to the minimum. Since it was a full cowl vehicle this time, it attached simultaneously with delivery of cars. Since green was
It was able to stand, although attached also to the vehicles which were before, and the crack of GOKE was able to be kept to the minimum.
Since it was a full cowl vehicle this time, it attached simultaneously with delivery of cars.
Since green was one of the things of an antlion although manufacturers of what were also only white and black, it could unite with the body color and is very much satisfied.
View detail
Since it has not fallen after purchase yet Whether it is helpful however is the main part width which is not in the product of the other company although it is unknown. Or [ that the logo of antlion is good ]!
Since it has not fallen after purchase yet Whether it is helpful however is the main part width which is not in the product of the other company although it is unknown. Or [ that the logo of antlion is good ]! View detail
Fits: KAWASAKI ZZR1400 (ZX-14), KAWASAKI ZZR1400 (ZX-14)
When it carried out to Schopp at engine oil exchange, the repair vehicle of ZZR1400 was set. Seemingly it fell and the ZZR had damage to right-hand side. However, the talk that damage to a cowl was able to be managed with the minimum, thanks to th
When it carried out to Schopp at engine oil exchange, the repair vehicle of ZZR1400 was set.
Seemingly it fell and the ZZR had damage to right-hand side.
However, the talk that damage to a cowl was able to be managed with the minimum, thanks to the engine slider was heard, and it purchased and attached instantly.
Because having used the product made from antlion had the cheap price and appearance was also good.
About an effect, since it has not yet fallen, it does not understand.
Prevention is also required.
.
.
View detail
Fits: KAWASAKI ZZR1400 (ZX-14), KAWASAKI ZZR1400 (ZX-14)
A manufacturer's accent is also in a duracon portion and it is with whether it is a joke just for a moment. Also when something is in it and it exchanges a duracon portion, it is fairly like knockout price. It is very well useful also for cowl pro
A manufacturer's accent is also in a duracon portion and it is with whether it is a joke just for a moment.
Also when something is in it and it exchanges a duracon portion, it is fairly like knockout price.
It is very well useful also for cowl protection of a full cowl vehicle.
View detail
Fits: KAWASAKI D-TRACKER [D-Tracker]., SUZUKI 250SB, KAWASAKI D-TRACKER [D-Tracker]., SUZUKI 250SB
[Buying motive] Since it is a dual par pass category vehicle, and the measure against an on-road run is also required, -KLX is. [Attachment] Although the object for -D tigers (-'06) was attached to KLX ('07), it has attached satisfactorily at all.
[Buying motive] Since it is a dual par pass category vehicle, and the measure against an on-road run is also required, -KLX is.
[Attachment] Although the object for -D tigers (-'06) was attached to KLX ('07), it has attached satisfactorily at all.
- The axle of an antlion, a swing arm, etc. are included, and since the axial length for penetration in their being cautions with the slider of a penetration type is a little short, as for the nut of both sides, all the mountains cannot be used up.
It is necessary to carry out this bundle only of 4 mm of each right and left in the state where the screw thread was made to remain.
[Others] It was illuminated that - book product can use it by KLX250 ('07).
- The vehicles after KLX250 ('08) will be considered to be satisfactory if D tiger X ('08) business is purchased once.
[grading of goods] - it is completely 5* without a problem.
View detail