Reviews
MADMAX Blinker
Purchased for Honda Little Cub. There are questions about the quality of workmanship, short wires. Didn't like the interior design. In the end, I assembled something in between the old kit and the new one. If it is impossible to purchase original turns, you can take it, the price is adequate. -------------------------------------------------- -------- Bought for Honda Little Cub. In terms of manufacturing, there are questions, short wires. I did not like the internal design. In the end, he collected something average from the old set and new. If it is impossible to purchase original turns, you can take, the price is adequate. Powered by Google Translator View detail
The construction is crude, but usable.
[How is it used?
I bought this Blinker of the cheapest CB400fourType because the STD Blinker was Pluschicky and cheap.
Was the one you received as per Image?
It is good that the blinker body is made of gold, but the finish of the plating and the manufacturing itself are cheaper than expected.
Was the installation difficult?
In addition to the blinker, the KIJIMA bracket, HURRICANE grounding wire, and Emon power supply cable were used to extend the cable.
Also, the Lens mounting screws were steel, so we replaced all of them with Stainless Steel ones.
In addition, the Relay and bulbs were replaced since they were also converted to LED.
How was your experience with it?
The light is working without any glitches.
[Included Parts:were they on?
There was nothing else in particular.
[Was there anything that disappointed you?
The plating may be thin, or the finish may be a little rough.
I was torn between the PMC one and the PMC one, but the PMC one is almost twice as expensive and the large size seems to be the smallest, so I decided on this one, which has a more faithful Four feel.
View detail
Plating is Beauty
Was the one you received as per Image?
It's almost exactly as Image, but the base is cheaply made.
[Points to note]
You need to pay attention to the Wiring, and it doesn't work according to the Instruction Manual. Both the wiring of the single car and the wire of this product must be cut and connected.
The pedestal has rusted within 6 months.
View detail
ZBlinker
I received the product today.
There is no problem with the appearance, but there is a BALI left when the bolt hole was machined for fixing inside the Blinker Bracket, and it is necessary to remove the BALI.
The inside of the blinker looks fine, but the packing inside the lens is not rubber, but SpongeMaterial-like packing, so I think it lacks waterproofness, but considering the cost performance, I think it can be recommended. I think it is a product that can be done.
View detail
It's good for cheap if you think of it as repair Parts
It's an OEM shape and it doesn't look like an Other Brand Product, but Since the lens is not screwed on but fitted, it is not the same as other manufacturer's Clear Lens etc. cannot be installed
Also, for some reason, Wiring's handling is from a different place than the OEM, so I'm going to have to change the Base part once I had to take it off and put it back on
The price is low and it's a good repair part
View detail
It is good making.
I attached it to the vehicle during Restore. Appearance is almost the same as OEM. Plating's texture is also good so I think that here is enough even if OEM is not available. View detail