It works fine!

[How is it used?
I replaced the tank cap with a one-touch type tank cap so that I can refuel the SPIDI when refueling the NSR250etc.

Was the one you received as per Image?
Some other impressions are nowhere near as good, but the one I purchased was not bad in quality and was perfect in terms of accuracy.

Was the installation difficult?
I was able to install it with Bolt On with Bolt.
The diameter will be 115mm Tank cap.

How was your experience with it?
It is easy to attach and detach with the One-touch when refueling, but the refueling port has to be put down once, which has its advantages and disadvantages.

[Included Parts:were they on?
Packing and Material:Stainless Steel Screws are included.

[Was there anything that disappointed you?
None in particular. It seems to be a bit risky as it seems to be hit or miss.

I would like to make it common for all manufacturers. I would like to see this standardized. View detail

Used on NSR250R Racer

It is very good and easy to key less. I think the price is lower than other companies' products.
However, fuel may leak if the vehicle body is tipped over.
Note that in Race, Cap changes may require filling the Tank with explosion-proof material. View detail

Cheaper than purity, solid Tank cap

Since the OEM Product for NSR250R costs about 20,000 yen, we purchased this one for Circuit Running.
Gasoline does not leak and is well made. It is also good that the Tank can be opened with one hand without using a key. View detail

Easy to refuel

I bought this product because of NSR-MC28, and I thought the key was troublesome when refueling.
I'm satisfied because I don't have to worry about refueling.
However, since the mouth becomes narrow, it is difficult to check the amount when refueling.
Of course, since there is no key, you need to make sure that you are not pranked.
Also, the Bolt that came with it was too short, so I prepared it separately. View detail

If you like.

It is installed to NSR250R.
It's nice that it's easy to remove without a key, but I thought it was a product of different tastes.
Is the back packing vulnerable to Gasoline? Deformed and melted when removed? It was like. View detail

Are they conforming properly?

Carbon Style's Tank cap has deteriorated and comes off, so Material : I bought Cap of Aluminum.
Appearance Design ? Reasons why prices were cheaper than other companies.
It's hot when it's hot and it does not touch with bare hands.

Bundled Packing is thick, and the attached Bolt can not be installed short.
Even if I use alternative Bolt 4 M dish Bolt does not sell long legs.
Cut the Rubber board of half thickness unavoidably
My own packing.
Although I could barely install it,
Parenthesis is bad at a state where it falls dented slightly below the tank surface.

Packing too thick for our bad dish Bolt.
I can hardly imagine that we are conforming to the vehicle properly.
We do not want to sell only with the general adaptation that Universal will work if it is a conventional Exclusive HONDA Motorcycle Tank cap.
Manufacturer's correspondence is not good either.
No reply from Wei Big !!!
View detail