- Home
- Product reviews
- Search reviews
Reviews
I want to add oil temperature Sensor efficiently.
When installing the UniversalOil cooler, I wanted to install the included hose, but the One Side can only be installed by cutting the Pipe, and the companion of the included hose is a Crimp, so I tried my best to modify it, but it was impossible, so I changed the hose to a Rubber type. I tried to modify the hose but it was impossible, so I decided to change the hose to a rubber type.
I also wanted to install an oil temperature sensor on the Meter, so I bought this one after much deliberation.
There was also an option to cut off the rubber hose and insert it in the middle of the hose, but we decided against it due to the cost and location of fixing.
We changed to HoseType, so the length and handling are now free.
It works normally
It is difficult to say "normal" because normal use is a matter of course, but the quality has to be good.
I can buy the quantity I want as a Single Item and it is Reasonable. I hope you will continue to offer products like this in the future.
View detail
Necessary and sufficient
Introduced as an installation component for Oil Temperature Meter when APE 100 was retrofitted with a meter.
Since the oil cooler was already installed, installation was relatively easy.
Since it is made of aluminum, a torque wrench is recommended for those who do not know how the aluminum gasket feels when it is crushed.
I was a little worried about mounting the Sensor, so I wrapped Seal tape around it as insurance.
There were no leaks that were there after a test run, so I would like to monitor it for a while on my commute and if it is Large sturdy, I would like to use it for Touring or something like that.
View detail
If the Screw part is a little longer
If the Screw part is a little longer, the protrusion of the Screw part is 6mm in between Banjo and me It was about the same level, but a little longer would have been perfect It was even better if it was in a different color View detail
1 in Mukawa / You can use it for 8 Sensor properly
I took the stick sensor for Oil Temperature Gauge of DNTachometer in Mukawa river from Drain bolt, but fitted to the return side of Clutch cover to fit Oil cooler installation
Unlike Drain bolt, since the Sensor directly touches the Oil, we think that comparatively accurate Thermometer measurement is possible
I tried to worry about the installation position but since I'd like to install Thermostat in the future, I decided on the Return side of the Clutch cover that can measure the Oil Temperature Gauge cooled with Oil cooler
As a result, it turned out that the effect of Oil cooler was too high and it was over cool, so it seems that it will be wearing Cover in Oil cooler somewhat (Lol)
It is a recommendation for people who do oil temperature control as well as water temperature
View detail
You can recommend it
We used it to take out oil temperature from Special clutch cover attached to APE type vertical engine.
Until now, we used the Oil Temperature Gauge Fitting kit to measure from Oil cooler hose, but since this item comes from Banjo bolt, if there is room in Clearance ahead of Sensor, we can recommend it in terms of simplifying Parts.
View detail
SP Mukawa It purchased in order to attach Compact LCD Thermometer (Type with external-energizer Back light) PT1 / with 8 Sensors.Although it is the combination of the Parts of other company, since it attached satisfactorily, it is satisfie
SP Mukawa It purchased in order to attach Compact LCD Thermometer (Type with external-energizer Back light) PT1 / with 8 Sensors
.Although it is the combination of the Parts of
other company, since it attached satisfactorily, it is satisfied.
View detail