Used to extend BlinkerWiring

Used to extend the Right Side wiring as it was too short when replacing the Rear blinker.
Naturally, we were able to extend it without difficulty. View detail

Wire standards

Both EmonAV1.25sq and DAYTONAAVS1.25 are probably stranded wires, but Emon has a thicker and softer coating, while DAYTONA has a thinner and harder coating, which is said to be similar to OEM harness. Incidentally, "sq" stands for "Square," and "AWG" is called "Gauge" (AmericanWire gauge) in the United States wire standard, indicating the cross-sectional area of the conductor section. AWG16 = 1.25sq = 1.31mm2. The larger the AWG number, the smaller the cross-sectional area. If it is just 1.25 and only a number, it may be the diameter of the conductor, but is there any diameter notation for stranded wire? View detail

Very inexpensive.

I would like to install a new Grip heater, but I would like to calculate if the heater is Large enough to interrupt the wiring between the USB port and the Relay. The maximum charge current of the two electrical components is 3.3A at 13.5V for the Grip heater and 4.8A at 5V for the USB2 Port (5V is switched on and off), totaling 8.1A. I bought Emon's AV1.25sq. The available power is 140W or less for 12V cars and 280W or less for 24V cars. If converted to allowable current, it is about 11.6A? Although it is within the allowable range, it is not as high as DAYTONA's AVS1.25 (A) of the same size.:Auto for Vehicle Low Voltage Power Line, V:Vinyl、S:The price is 1/8th of DAYTONA in unit length, and Emon is very cheap. By the way, it is another Wiring, but the most large current of ETC on-board unit seems to be less than 1A because it is 1AFuse, although only standby current was written. View detail

Wiring as usual

[How is it used?
I had been using it for wiring work and bought it at Home centeretc. when I noticed it, but I ran out and had plans to shop at Webike, so I bought it along with the other products.
Fine wire 0.5sq is used for those with low power consumption, while Others basically use this 0.75sq.

[Was the product you received as Image?
It was just like the picture.
I always use the safe Black Wiring.

How was your experience with it?
This is a standard Wiring Cord, so the product is solid.
Emon's Wiring Cord allows you to hook up excess wire with the Holder, so you don't have to worry about it being RoseRose the next time you use it.

【Review】
It is inexpensive, readily available, and of consistent quality.
It is also convenient to keep Wiring together.
I always use Emon's Wiring because it has no problems with heat resistance, oil resistance, etc. for use on motorcycles. View detail

Unwavering Reliability & Quality 3

Unwavering Reliability & Quality
It would be a shame if there were more color variations.
Sufficient product for amateur DIY View detail

Unwavering Reliability & Quality 2

Unwavering Reliability & Quality 2
Easy-to-use Point with a hole in the take-up table after use.
I know there are other products that are probably used by PRO electricians.
This is a great product for amateurs to use for DIY! View detail

Unwavering Reliability1

Unwavering Reliability & Quality
Easy-to-use Point with a hole in the take-up table after use.
I know there are other products that are probably used by PRO electricians.
This is a great product for amateurs to use for DIY! View detail

For Wiring Processing

This is essential for Wiring processing.
They are inexpensive and come in a variety of colors, making them very useful. View detail

Cheap, safe and easy to use

[How is it used?
When I was working to install YOSHIMURA/Oil Temperature Meter on XJR400R, the attachment wiring was too short to reach DAYTONA/D-UNIT under the seat, so I used this product to extend the wiring and installed it successfully. I extended the wiring with this product and was able to install it successfully.

How was your experience with it?
Very easy to use
AVS 0.50sq is often used for electrical components in motorcycles, so those who often tinker with electrical systems should have one in their tool box.

How did it compare to other products?
Basically, we only purchase electrical components from Emon, but you can easily find them at Home center or other places. However, it is much cheaper to buy on the webike.

[Points to note]
Nothing in particular, but it is safer to use dedicated tools for crimping and crimping firmly to avoid trouble. View detail

Used for Wiring on Motorcycle navigator!

It is long enough and strong enough not to break. The colors are good, and above all, it is very inexpensive!
It's Recommendation! View detail

RedBlackIt is useful to have.

Wiring in Emon.
We use it for basically everything.
For Motorcycle, I used it to pull Wiring for ETC.
1.25sq" refers to the thickness, which is the same size as the Wiring used for Air guns (Electric Gun).

If you just want to play with Motorcycle normally, you will use the existing Wiring, so you will not use it much.
However, it is very useful to have this kind of toolbox for electrical tools in the rare cases when you want to use a small amount, such as additional Wiring or Wiring branching.
It is convenient to have one of each along with the Red color.
It is also good that it is easily available at home centers, auto for vehicle supply stores, and Motorcycle supply stores in case of a sudden need.

In my case, I have a lot of opportunities to use it in some way, such as creating additional Wiring for playing around with cars or using it in electronics work. View detail

The cable of 0.75sq purchased to an electric spectaculars and electric reconstruction. Although the line of 0.5sq is sufficient as a matter of fact, I would like to use here in Black's single and the scene where capacity is larger. It is in the st

The cable of 0.75sq purchased to an electric spectaculars and electric reconstruction.
Although the line of 0.5sq is sufficient as a matter of fact, I would like to use here in Black's single and the scene where capacity is larger.
It is in the state which is still waiting for that time now.
The 5-m size which can be used with a sufficient degree is good exactly. View detail

Large Activity

External Tachometer installation
Used to pick up the Pulse signal.
We were able to differentiate ourselves from other Wiring View detail

The quality is good enough for my needs!

Emon is a friend of the common man!
It is Exactly for extending Wiring, adding Grounding Wire, etc.
I think any Wiring can be covered by crimping a separate terminal to this cord. View detail

This is the first thing to do when tinkering with electrical components

Item number:E177

Used on various Motorcycles.
This is a normal conductor for cars/motorcycles.

The best part is that it is inexpensive.
0.You can get 20m of 75sq for less than 700 yen.

Electrical tinkering is a clean attempt.
I'll cut it longer for now.
↓
Fine-tune while Routing
Therefore, the cosmetics that can be used vigorously are justified.

In addition, this product is for cars/motorcycles at this price, so it has a certain degree of heat/weather resistance, making it relatively safe to use.

By the way, regarding the thickness, even 0.5sq can be used for Large and a half things since it can go up to 60W.
Personally, I prefer to use it without thinking about anything except where a very large current flows, so I use 0.75 sq. more often with a margin of safety.
However, when it comes to 0.75sq, when you want to branch, Quantity to general terminals.:In this sense, it may be preferable to use 0.5sq regularly while considering power consumption, since it becomes Limit when 2pcCrimp is used.
Well, this may depend on the mindset of the worker.

If you tinker with electrical components in your car/motorcycle, this is a standard product that you should buy at least once.
In the meantime, why not start by buying Red and Black of this? View detail

It took me five years to use it up.

Red is Plus and Green is Minus in Image, so I bought the safe Black.

Black is inconspicuous and can be used for anything. View detail

A thickness that is often used

0.The 75sp is a thick wire that is often used when doing electrical work on motorcycles and cars, but until recently I had been reusing the harness from an old car navigation system. Because a considerable length remained, I have used it for various things, but I came to purchase it because the stock finally ran out, and I chose Black and Blue for some reason because I had many opportunities to use it for Minus.
This time I made a Wiring with Coupler to attach the Blinker relay to the car body, I used about 15cm of it and it has 5Meter so it looks like I won't need to buy it for some time to come. This kind of item can be bought in just the right quantity, and there are more opportunities to choose Emon, which can be used with confidence in terms of quality. Of course, after all, a new one is soft and easy to handle unlike a used one. View detail

For Power Distribution Wiring

It is a purchase together with Connector to do Wiring for power distribution.
I didn't need that much length, but I had no choice.
It was also sold in the nearby Shop, but the price was a little higher here, so it was a hassle to buy it together. View detail

For Wiring

I bought this with the Connector for Wiring distribution.
I didn't need that much length, but I had no choice.
Wiring is a purchase of Red to identify.
It was also sold in the nearby Shop, but the price was a little higher here, so it was a hassle to buy it together. View detail

Easy to use

[How is it used?
I usually use it for additional Wiring etc., but I bought it again because the one on hand was lost.
Basically I use 0.75sq, but this time it was the WiringRepair of Small TypeMotorcycle which does not use power so much, and addition, so I chose the thin wire 0.5sq here.

[Was the product you received as Image?
Photo
The length is 5m and quite a lot for cheap, so it's enough for Sunday mechanic.

How was your experience with it?
It's just a normal thin wire Wiring Cord.
Even though it is a fine wire, it has a certain diameter, so it is not difficult to crimp.
The good thing about Emon's Wiring Cord is that you can hook up the excess wire on the Holder.
It's nice to be able to keep all the extra lines together, since you basically have to keep them unless you need them.

【Review】
It's inexpensive, easy to use, and convenient for keeping all your Wiring together.
I've always used Emon's Wiring because I've heard that it has no problem with heat and oil resistance. View detail