No Recommendation on buying if you want to pimp

I bought it for MONKEY because I had used it for APE and didn't have such a bad impression of it.
It doesn't look bad,
When it comes time to install it, it is a rickety gubba-gubba.
First, the Pivot part. This is the most important part.
It comes with four Pivot Collars.
All four are RoseRose in length.
And the Pivot Collar is not long enough.

Shim adjustment is made to the width, though,
Even if you don't want the width to rattle.
The Pivot Collar is not long enough and the Swing Arm does not move when tightened.
This can only be solved by rebuilding the Pivot Collar itself.
Then, the Shaft is passed through the Pivot Collar,
It is rattling.
Since the shaft is OEM, the inner diameter of the Pivot Collar seems to be Large.

So even if you could adjust and tighten it well at this point
Even with the Shaft in, the Swing Arm is still Oversized, so the Swing Arm will be out of control.

(One-off color is the solution for us)

Next, WheelAxle Shaft.
While the outer diameter of M12Shaft is approximately 11.92~mm
Rear axle bore diameter is 12mm or more.
This one is also rattling… This one is… already!

I thought Chain Adjuster would be nice too,
There is no reference line on the Shaft side, so you have to mark it to know….

These two points. [Color] I need to Clear.
Dangerous while driving.
I really wanted to return it, but I opened the package ….
I mean, it's not like this is a non-returnable issue if you don't know how to put it on.

I understand a certain amount of QUALITY.
This one was kind of the worst….

Oh, and for the Drum.
The Brake Rod also requires modification.
It has to be angled a little to hit the suspension bracket.

It's something for people/experts who already have … lathes and such.

WeBig sometimes has a Sale.
I regret that I should have worked a little harder and bought GCraft's Swing Arm.

If anything, Tanaka Shokai's Swing Arm is better.


Is anyone using this as is 、、、、? View detail

MONKEY Long Swing Arm

Buy 12 cm to make it LOW Long. I thought that some processing is necessary because it is made in a foreign country but I can install it without machining Racing Stand Hook arrived and I think that Cost performance is pretty good. View detail