Reviews
Purchased for kSRPro
Purchased for Kawasaki KSRPRO.
Since it was for the entire KSR110 period, we contacted NITRON, but the person in charge did not know. The answer was, "We don't know. They said it was because they did not cover all car models.
In case you are wondering, it is KSR, so Challenge.
Results to be reported
View detail
Highest performance
I purchased this product after searching for a suspension that allows adjustment of both rebound and compression damping.
The z125 has few Other Brand Product rear suspensions, and the ones from Ohlins were not fully adjustable, so I chose the Nitron.
The R3MODEL is a Tank Separated Type, so installation took a little longer, but the z125 is easy to Access to the Rear Suspension, so it only takes 30 minutes.
The weight Spring rateOrder could have been made at the time of shipment, but because of my average height and weight, I had it made once in the Standard state.
I had a friend who is a racer do a rough setup for me, and it made it much easier to ride.
Front fork also spare Quantity:I changed the Set to Spec. and adjusted it, but it now bends well anyway.
Also, the behavior of the rear is now easier to grasp, so I am less likely to mock.
In the past, I would suddenly slide in a large radius and then slip down, but since switching to ITRON, I can see the behavior as I start to slide and can control it, so I can do TimeUp with almost no falls.
Overhaul is also possible, and the spring rate can be changed for a fee.
In addition, due to the mounting position of the separate tank, if you install the Up type exhaust system, it may become worn out due to heat.
View detail
NITRONSuspension installation
The suspension length is 1-2cm longer than OEM, so it looks a little bit forward and backward. I bought and installed the one from the previous year, but it is not a simple installation, you need to make a simple bracket or make a hole for Tie Wrap. View detail
Fits: HONDA APE 50, HONDA APE 100
Large satisfaction excluding the price.
It also wrote in Impre being used, but ease of riding, suppleness is the best. Corner stability is good, you can overcome Corner with confidence than ever. I do not take long distances, but I think that we can reduce the tiredness of the body as well. View detail
Fits: HONDA APE 50, HONDA APE 100
Appearance Texture Usability is all the best.
I like all of them.. However, I was concerned that the price was a bit high. It should be hard, but supple, I thought that it was quite stable with Corner. I think that trackability to the road surface is good. Traveling around the town at low speed is supple, and it is easy to ride considerably. Spring is 19 kg / mm, Swing Arm is 4 cm long, weight is 75 kg. Spring's adjustment tool was also Parenthesis nice construction. View detail
Normal suspension is a great product not to compare.
I used it for Grom's 181 Full Custom.
I wondered which way to do with OHLINS, but compared with the splendor of Cut-out, Coloring, etc. Results I decided to purchase this item.
It is also decisive that less people are attached.
If you remove Jack-up lightly by removing Ride's Side cover, you can install it easily and easily.
At that time, I will also Grease up each part.
Because NITRON is becoming a new coloring, it became a very beautiful and calm feeling, a sense of quality appeared!
I immediately tried it, but it does not compare with Normal suspension!
The feeling of being clattering disappeared, and bouncing by Gap also ceased.
The corner ring is really fun and Motorcycle itself is a different thing.
I ran about 100 km, but the pain of the buttocks improved considerably.
I think that this product, the price seems to be a little expensive, but I think that it is a terrible product sticking to every detail.
It was nice to really buy it.
This is a wonderful product that I can recommend Recommendation.
View detail
Fits: HONDA XR50 MOTARD, HONDA XR100MOTARD
It is the best item above the price.
I used it for full Custom of XR 100 MOTARD 145 cc.
Up to now it was OHLINS, but there is only setting for APE, 17 kg of Spring rate was Standard.
From the APE, the XR 100 was Swingarm 4 cm long, and replaced with Over 5 cm Long Swingarm, so the total was 9 cm long.
With this, 17 kg is too soft.
It was not good to multiply the Initial or tighten the Damper.
So, it is a search by Wei Big's site.
There was! NITRON!
If it's kore you can choose the Spring rate, making it looks pretty good.
The Spring rate chose 20 kg, but it did not become Solidly, it became a supple cat paw.
I have weight 78 kilos, so I finished it just fine.
Although it is my subjectivity, if OEM Length's Swingarm is 18 kg. If 5 cm Long 19 kg. I think if it weighs more than 75 kilos it is 20 kg..
Color is becoming a new model, and it is becoming increasingly astringent.
The feeling of running is not stable bouncing on Gap and it is very stable.
It really makes me feel like I got better.
The price is a little expensive, but I think it is a more valuable item.
I'm glad I bought it!
This is a wonderful item that can really Recommendation!
View detail