- Home
- Product reviews
- Search reviews
Reviews
Fits: SUZUKI GSR400, SUZUKI GSR400
Some parts are incompatible
GSR400 (Gk7EA) Purchased for a 2010
Replacement is possible without any difficulty. Just by changing rusty OEM Bolt to Titanium, it will look better. But! The BridgeBolt was fine, but the Pat pin was not able to fit.:The 2pc did not work. It is necessary to pay attention to whether the person who considers the purchase fits Caliper of your vehicle. It is a product of about 15000 yen. 5 pieces each of One Side, Quantity of 10 pieces in total.:Since it is a Set, Quantity:For about 3,000 yen for 2pc, I became useless. The feeling of use is …I think that there is a thing that the Pin part has not been exchanged, but I was not able to understand it to myself of the amateur to say "HADRILL". But well, I think it is good because the appearance has been improved. It is expensive.
View detail
Fits: Others Brembo 40mmCasting caliper
You can use it for the new Crab caliper, but at your own risk.
[How is it used?
Used for several weeks after installation.
Was the one you received as per Image?
Repeat, so Image Street.
Was the installation difficult?
for FrontQuantity:This time I used the set for the rear caliper, but since the caliper size is too small, it is difficult to remove the bridge bolt with torque, so I installed it on the support.
In addition, since the Caliper is split, a little CCIMetal rubber is applied to the rubber packing of the Breeder to make it easier to blend in and prevent leaks.
How was your experience with it?
First of all, it is resistant to rust.
Next, OEM pad pin of Rear caliper is press-fitted and Retainer is attached, and it is difficult to remove and install. This time, I was able to divert the pad pin of for Front, and the work of removing and inserting the pin has improved remarkably.
[Included Parts:were they on?
None
[Was there anything that disappointed you?
If I had to guess, I'd say Quantity for Front:Where only Set is released and Bolt is Quantity.:I have an extra 2pc w
Other items that would be helpful
Points and hangs for installation:When removing and installing the BridgeBolt, it is easier to apply torque with the Caliper support installed.
Manufacturer's Suggestion:Since we converted for Front this time, we would like to make a new pin for Rear only, for RearQuantity.:I would like you to Release Set.
View detail
Fits: Others Brembo 40mmCasting caliper
You're right, it's rust proof!
[How is it used?
About 3 years have passed since the installation.
Was the one you received as per Image?
It was unexpected that it was packed in Small Case than I imagined, but the product was Titaniumium blue color as Image.
Was the installation difficult?
I had to disassemble the caliper first to refuel the piston and seal, so I had to change the bridge bolt. So far no leaks and everything is fine.
How was your experience with it?
I can't feel the lightness.
However, it is good for my mental health that there is no rust even though I drove in the rain a lot.
[Included Parts:were they on?
None
[Was there anything that disappointed you?
None
Other items that would be helpful
If you have a wrench that can measure the torque, you can know the tightening torque.
View detail