There are difficulties in installation, but functionality is enough

【What made you decide the purchase?】 I bought it because I wanted a Guard with SMART shape when protecting hands from flying stones and branches.
【How was it actually used?】 Functionality was enough. Just because the branches hit the fingertips depending on the installation, we have difficulty positioning Wiring and Guard.
【Was it difficult to install? (Hard parts case)】 In my case I cut off the part that corresponds to Wiring. If that is the case, it cracks when it falls, so we attach it with Screw as a subsidiary of the Stainless Steel board.
【Please tell me the point of installation and hang (in the case of Hard parts)】 It is the same as above, but if Wiring inevitably collides, I think it would be better to shred the Guard. Just round off the corner or Wiring will hurt unless you paste the rubber.
[Is there anything I was disappointed about?] I thought that it would be easier to attach, but it was unexpected that Accelerator Wire would hit it.
【Hope for Manufacturer - Please tell me if there are any improvement points】 I think if there is a movie of installation etc.. We also purchased Poly sports products, but the information is for FOR JAPAN MODEL - Often not going out abroad.
【Have you compared items?】 Similar products of ZETAHand guard and Poly sports
[Others] Because it is easier to slip through the trees than Aluminum's hand guard, I purchase such a product. With color with White with falling with White, it will fall, but I do not care because it is not noticeable. Moreover, since it never folds even if it falls, I think that it is not something that will be broken soon.
The color in the case when White became reflected in the 2nd photograph and Screw of the shaved part (Right Side as seen from the front) is. View detail

Installation on dTRACKER 125 requires modification

dTRACKER 125, Olm Handlebar of Klx 125. Brake side is attached without problems. On the Clutch side, Quantity : Pair (for Left and Right) Hitoshi etc. , It is necessary to cut the welding part of BrakeHose Holder diagonally with the Grinder and also to cut off the Clamp part of this product. Once attached, you are firm and bush will fully protect Lever. Because it is a shiny material, I think that there is no problem in terms of strength. Bar EndOpen Type you can install it cheaply on the OEMHandlebar. View detail