- Home
- Product reviews
- Search reviews
Reviews
Gusseted and made of Gold genus, RM250 (K3) Punching without machining to
Use Situation……Situation is on uneven ground in EDCourse for use with MXer's EDModify. Purchased for the purpose of making it stand on its own on the soil when taking a break from running.
The effect……is extremely Large. it's too nice not to have to search for the perfect tree to stand on one by one anymore.
(Required for installation) Included parts other than STANDBody:1 pc of plate Hexagon Socket Bolt, 1 pc of normal Hexagon Socket Bolt, 1 pc of plate Hexagon Socket Bolt, 1 pc of plate Hexagon Socket Bolt, 1 pc of plate Hexagon Socket Bolt, 1 pc of plate Hexagon Socket Bolt, 1 pc of plate Hexagon Socket Bolt, 1 pc of plate Hexagon Bolt. (with Washer Ki) The upper side is co-tightened with the sub-frame, and the lower side is co-tightened with the Chain Guide Roller. The upper bracket is co-tightened with the sub-frame and the lower bracket is co-tightened with the chain guide roller. The Hexagonal Wrench should be a type with a ball point tip. When tightening the lower chain guide roller and bracket together, it is tightened from the inside of the body, so the Straight Type Hexagonal Wrench cannot reach the bolt hole because the LINK is in the way. This is a little bit unsatisfactory, because the OEM bolt is a normal hexagonal flange bolt, so it may be possible to replace the bolt with a new one that is the same length.
Quality and texture……The name of the product is "Kick Stand" and it is a material like KTM.:Compared to the poor plastic Side Stand, it is made of gusseted gold, and the finish is beautiful and not cheap. The side stand body is a little heavier than the plastic side stand.
How it feels…… I don't feel like it will break even if I KICK it around on the footpeg while STANDing it out. It seems to be very sturdy. The toes are also wide enough to not worry about sinking into the soil. However, the STAND itself is a little long, and when the air pressure in the tire is low, the angle is not so good. It could be 2 cm shorter.
View detail
Fits: KAWASAKI KX85, KAWASAKI KX80, KAWASAKI KX100, KAWASAKI KX100, KAWASAKI KX112
Bolt is not strong enough.
The quality of the STAND itself is good as it is machined, but the fitting is the worst.
After installing and checking the STAND in and out, and finally checking the tightness of the Bolt, it was loose.
After retightening and checking the operation, it loosened again.
I thought it was strange, so I took it apart and found that the Bolt was bent.
I did not straddle it with STAND, and I think this is terrible, no matter how much it is racing parts.
View detail
It's well thought out
I bought it to X-ify the unmarked
Features
? When bouncing up, the rear end is stored behind the RearNumber Plate
The ?Spring is built into the body mounting area and looks great
Thanks to these two points, even if you're doing something Hard, STAND won't get stuck with anything! And there is no damage
View detail