Used for ninja250R

The blinker of the NINJA2 Helmet50R broke, so we diverted this one.
Cars with similar holes can usually be installed.

Unlike the OEM stick blinker, the Small is hard to see because of its poor angle.

I think the design is good and modern. View detail

Too big NORMAL to Sharp

Installed on z125 pro
A little modification is required for installation.

However, the Blinker display in the Panel doesn't blink after I put it on, so I'm thinking about what to do. View detail

Blinker installation on the grommet

The same product was listed for use in a grommet before, but it may not have sold well or it was discontinued before I knew it

So I've been doing some research and I found this very similar product
I ordered it after comparing it with the photo for the Grom and figured it was the same, and it was the right choice!
Fit like Exclusive Design!
If it's the same thing, maybe it's obvious, lol

Installation is also possible by removing the OEM Blinker and inserting it into the OEM Blinker and using the attached Washer and Nut Just tighten it!
All that's left to do is hook up some random wirings and you're done!
There are only two lines coming out of this blinker, so the position light is sacrificed, but There are workarounds, so look for them View detail