Reviews
Required Size for Koken Hose
I bought a battered 900SS (900SL) and am Restore.
DUCATI has adopted OEM brembo Master Cylinder and Caliper, but DUCATI of this era has Parenthesis bad Square Type Reserver tank integrated Master Cylinder, so it is often replaced with Reserver tank separate type. However, DUCATI of this era has often replaced the Master Cylinder with a separate Reserver tank.
After 30 years, such brembos are already in shambles, and if they are stored outdoors with no maintenance, they must be in pretty bad shape.
Hose connecting Reserver tank and Master Cylinder, but it is basically Rubber.
If you use a cloth-wrapped hose made by bremboOEM, it is still fine, but if it is not a cloth-wrapped hose made by another brand product, the surface should be white with pushing.
If a translucent Oil Resistant Hose were used, it would be so stiff that it would be impossible to pull it out.
So, I bought a cloth-wrapped Hose kit from Koken to replace it, but the problem is that this Hose kit does not have a Hose clip in quantity.:2pc. Only Set should be included.
No, normally it should be Large sturdy with it, Cut to the required length and fixed, but the rest of the Cut should be too short to be useful.
However, if it is cut well and used in two places, there will not be enough Clip.
Here is a Clip set for such occasions.
You don't have to use such an expensive Clip, you think UniversalClip is fine, right?
However, this is not the case. When bremboOEMTank and KOKEN Hose are combined, this Clip must be used to achieve the best tightening.
To reproduce the same tightness, you should definitely use the screw type.
Since it is a plain steel clip with a black coated surface, it is rather easy to rust it, so if you are concerned about its appearance, it is a good idea to replace it periodically.
View detail
Replace with new one
When replacing the brake fluid, the hose clamp was also replaced along with the oil hose.
It was helpful that Single Item sold it at an affordable price.
View detail
Very good Size
[How is it used?
Touring, city driving
Was the one you received as per Image?
Street Image
Was the installation difficult?
It was easy.
How was your experience with it?
It was good
[Included Parts:were they on?
It's not attached.
[Was there anything that disappointed you?
Easy to rust
View detail
For bremboOEMHose
[How is it used?
Brembo master is installed on MainMotorcycle's XJR1300C and Racer's YZF-R25 MASTER.
Oil hose from bremboOEM is 9.5Φ Clip that comes with brembo tank kit is not so good......................................
I was looking for a good hose clamp and found this product.
So far, the Fluid leakage and other problems have been completely solid, so I can safely recommend it.
Was the one you received as per Image?
The surface finish is even better than Image's! The price is cheap and the two-pack is easy to use.
Was the installation difficult?
It's not hard to do
Even if you want to replace only the clips, you have to disconnect the oil hose once.
I think it is better to do it with Timing to remove Brake fluid such as Fluid replacement.
How was your experience with it?
In a good way, it is insanely hard. It's tough to spread Clamp with bare hands.
It should be properly pinched and spread with radio pliers, but it is better to apply Dustcloth or something else before applying the tool because it is easy to scratch it.
Also, it is quite tight when passing through the Nipple section. If you try to pry too hard, you may damage the Nipple side.
After moistening the brake hose with Parts Cleaner or similar, slide it into the brake hose.
It can be installed without giving Stress to the surrounding Parts.
[Included Parts:were they on?
As shown in the picture, ClampQuantity:2pc. Nothing but Set.
[Was there anything that disappointed you?
Nothing in particular. If I had to say, I'd say it's too hard and could be softened a bit.
I think the knob could be made a little bit larger to make it even easier to use.
View detail
It improves the appearance of theHose.
Not only the appearance but also the deterioration of the fluid can be visually observed, which improves maintainability. View detail
Brake fluid leak stopped.
Used to fix hose between Brembo master and bremboTank.
Previously fixed with Tie Wrap, but Fluid leakage occurred.
I fixed it with this Clamp and the leakage stopped.
View detail
Good Quality & Packaging
The quality of the item is good without any scratches. The item was packed properly even a small piece. So far the item is good as expected. View detail