I put it up

There is an Instruction Manual, but the actual work is quite difficult to do
Rear cowl is divided into two parts from the center, and the center part is overlapped It will be a paste
It was very difficult to finish this stacked area and the treatment and finishing of the area near the footpeg
In my case, one of the tips was stretched out because I was applying hot air to it while I was finishing it, so I had to use a different method to make it work under the Seat I removed the UnpaintingCover and cut it a bit

My personal work time was about four hours
We use an air-compression type horticultural sprayer
It's safer to buy a dedicated Squeegee

Anyway, it takes a lot of patience and time, but you'll be happy with the finished product (Lol)
The finished product is much more flashy than it looks in the product image

Will the rim of the rim be able to survive the winter without peeling off?
That's what I'm concerned about
By the way, the Matte paint part certainly sticks without any problems, so don't worry if you're worried about it View detail

I haven't put it up yet

I think this is the only Decal for the CYGNUSX Type 5 at present
What was different from my expectation was that the Application Sheet, which will be used to align and protect the printed surface as well, has been added to the printed surface It's what didn't happen
If you don't have a Squeegee, misting or degreaser, you can't get a scratch on the printed surface Use Squeegee and provide your own misting equipment Parts cleaner can be substituted for degreaser
Dryer is also a must

As I watched the video, I had the impression that it was quite difficult, so you may not be able to put it up beautifully unless you have some experience with it It is not

Also, depending on the color, the side cover is Matte painted, but I asked MDF It can be applied properly where The answer is that it is
View detail