- Home
- Product reviews
- Search reviews
Reviews
Fits: SUZUKI GSX-R1000R, SUZUKI GSX-R1000
The Rear Sets are now the loading space!
I'm using it to install GIVI's Mono-lockSeries!
The GSX-R1000R is an Other Brand Product, but also has a Rear Carrier Because it is not sold and Seat bag does not have enough carrying capacity and water proofing performance For large capacity loading & security & waterproofing, a rear box is installed Decision Purchased
The price is a little high, but when I installed it, Large processing is not necessary, and it is a little pompously installed I'm happy with the installation and Large variant!
As a general comment, there is no large wobble, and I can use Rear Sets and Carrier depending on my mood It only takes me a minute to make the switch
I don't want a permanent Carrier on a regular basis! I only need to use the tear box for touring This is very much a product of Recommendation if you're not!
(There is a slight reluctance when locking to the Rear Sets, so if you are concerned about it, the Rear rack side may need to be beveled a bit.)
Normally, in the case of the Rear Carriers like Pipe, the maximum loading weight is about 5kg Subtracting the weight of 5kg of the tear box, the weight of the load can be reduced by putting the tear box on the ground I guess it's fated to be in the mainstream state of Limit and not be able to put anything too heavy in it the..
In the case of Rear Sets replacement, there's no Risk to break, so I'm pretty comfortable with that!
When you put a heavy object on it, there is a possibility of damaging the lock part of Seat measure
Please refer to the following instructions for installation
When you install the Base of GIVI Mono-lock, you need to check the position of the hole on the Base side and the position of the base The holes on the rear rack side do not fit perfectly, so be careful
The two holes in the original and the Gold genus on the reverse side of the rear rack Replace the bolts holding the parts with GIVIBase parts and tighten them together (See the second image of the image)
It is necessary to fix the GIVIBase side of the Bolt 3 points, but the Bolt that comes to the Center In order to fix the top cover of the Base, you must turn the part where the screw holes are located into a Drill or Nipper Drilling process by using a (Image Quantity:1 Set of 4 pcs. See eyes)
? Plug the holes on the side of the rear rack that you are not using with appropriate tape (See the sixth image.)
Use three bolts attached to GIVI to fix the base and the rear rack
At this time, because it was judged that the wavy Plate of GIVIBase attachment was unnecessary, Home I installed a Washer purchased at center instead (Refer to the fifth image of the image)
? When you install it as it is, there will be a large gap between Seat Cowl and the side of the rear rack You will not
Because of the gap of about three centimeters, rain and dust can get in as much as they want, and if you work hard enough, you can take out the stuff inside Level, so it's a Waterproof Crevice Tape sold at Home Center (Thick Sponge that won't soak up water) Overlap and paste (Images 3 and 5.)
View detail