Reviews
BALI shaving required
The Normal Throttle has a large pull allowance, so there were times when I had to re-grip it when running at full throttle, but this has not happened since switching to this product. However, this has not been the case since we switched to this product. Also, the Axel does not become too severe due to too high Solo, and the Throttle is now an easy-to-use Large Throttle.
When installing, there was a small BALI (less than 1mm) at the part that fits into the switch box, and when I turned the throttle, it jostled, so I had to shave the BALI and flatten it. It was not a large job, but it took a long time to install because I did not understand the cause at first. I recommend that you shave the BALI before installation.
View detail
wrist health
Quality and texture information Std is close to the wire holder, not the product I feel less pressure on my wrist It's not easy to install Cost performance and comparison with other products are really good WeBike packaging is always great. Arrives in a week for delivery and packaging Concerns, precautions, and advice on purchasing If you repeatedly wind the roll over a short distance, your wrist will get tired, so I recommend it to those who are driving around the city View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
To put on the Grip heater
Prepared for Grip heater.
Used to omit OEMThrottle processing.
I spent a lot of time adjusting the Throttle play, so I may not have shortened the result (laughs).
View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
Good part
Put this on my msx125, feels much better, takes less rotation of the wrist to reach full throttle. Fitment is perfect and quality is as good as an oem part. View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
It is easier to turn Axel.
It was quick and easy to get to Top speed. View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
Slightly quicker throttle action but a bit flimsy
The work required to swap this over isnt worth it in my opinion. I aslo notice i can lower the idle speed but putting pressure on the throttle. View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
SmallEngine Displacement VolumePower up is a man's romance lol.
SmallEngine Displacement VolumeIf you drive a car on a hill, you have to turn it, so you have to open the Axel a lot, don't you? It's fun to use SmallEngine Displacement Volume to turn the car around. By the way, Gixxer 150 for MONKEY125 can be installed without any modification. View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
Cheap! And High Solo!
I bought this to save the time and effort of removing the OEM grips from the OEM Throttle and grinding out the bumps when installing the Grip heater. In case I need to go back to OEM, it's still Kan Tan.
When installing the ThrottleWire, you may need to remove the Leg shield to free the lower end of the ThrottleWire. I did this at the same time as installing the grip heater, so I had already removed the leg shield for wiring.
After the installation, I heard that it is 25% higher solo, but I didn't feel any particular change. However, if I use the same amount of control as before, the Axel will open up to Large fine-grained, which may reduce fuel efficiency a little?
No problem, as it is a fun ride.
View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
There is a BALI and it needs to be cut down.
The BALI is on the opposite (lower) side of the Thailand coil position on the wire and I can feel it catching just before full throttle.
If you shave BALI, it becomes Smooth.
View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
High Soloing
I changed the Grip and also Throttle.
Replaced. 20%Higher Solo
That's right, so I was wondering.
It's not that dramatic of a change.
Axel opening is a little easier.
The price is cheap, so I'm satisfied.
View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
Even more fun riding with the quick throttle
I ordered the Kitaco super throttle pipe as I was changing my handlebar setup and did not want to reuse the OEM Honda grips and I read that the grip is very difficult to remove from the original throttle tube. Very basic looking product at an extremely low cost. Releasing the tension off the throttle cables is required for installation and then adjusting them for correct operations is a must. I have to say I wish I had installed this product sooner as it seems to making riding the Honda Monkey 125 even more fun due to giving the motor more gas with the same twist of the throttle I would have given it before. View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
It is convenient Goods.
I used to use this product on my previous motorcycle, but I think it is a must-have product when replacing the grips on my current motorcycle with non-OEM Parts grips. This is a must have product if you are replacing the grip on your current motorcycle with a non-OEM parts grip. View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
SUPERSlotPipe
The AxelSlot of CROSSCUB110 is not able to open the Axel fully without releasing the hand. View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
Not too small, not too big.
High Solo is a product of Throttle part only.
Therefore, extreme High Solo is impossible in size.
If you take this into account, the wide Throttle opening of NORMAL will be narrowed to a moderate opening degree.
Because the price is cheap, I think that it is good to try it if the Throttle opening degree of NORMAL is concerned.
View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
Super throttle pipe for KITACO Monki-125
I purchased this product without reading the product description carefully.
It's for the MONKEY125.
I have no plans to use it in the future, so I wasted it.
View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
Recommendation to light tune
I installed it on my MONKEY125.
It can be installed with no problem if you can do simple maintenance on the Level.
We replaced it when we replaced the Grip.
After installation, the wrists are easy on the wrist with High Soloization, as aimed.
The Throttle is especially effective because it is used constantly.
It's a Recommendation because the price is so reasonable!
View detail
Fits: HONDA SUPER CUBC125, HONDA DAX125, HONDA SUPER CUBC125, HONDA MONKEY125, HONDA MONKEY125, HONDA CROSSCUB110, HONDA CROSSCUB110
While changing the Grip
I bought it while I was installing the Grip heater
It can be fitted with external grips with no problem of accuracy
High Solo is nice too, because it's less open than the OEM
Recommended for people whose wrists get sore when fully opened in OEM
The price is cheap and large, and I'm satisfied
View detail