- Home
- Product reviews
- Search reviews
Reviews
Fits: BMW G450X, GASGAS EC, GASGAS MC, GASGAS XC, HONDA CR125, HONDA CR250, HONDA CR500, KAWASAKI KX125, KAWASAKI KX250, SUZUKI RM125, SUZUKI RM250, YAMAHA WR250F, YAMAHA WR250R, YAMAHA WR250X, YAMAHA WR450F, YAMAHA YZ125, YAMAHA YZ125X, YAMAHA YZ250, YAMAHA YZ250F, YAMAHA YZ250X
Effective! But...
I put it on my YZ125X, which has a‘21 footpeg. The OEM product number I checked was the same part number for both the footpeg and base installation, so I figured it would fit.
Result is Normal position is OK, Low Position is footpeg stopper (Adjustment by putting Washer in Screw) The head of the base mounting screw? The head of the Screw on which the Base is mounted?
The footpeg is designed to tip up when the footpeg falls over, just like the OEM model, but the part where the spring hangs on the footpeg side hits the mounting screw on the base and only raises the footpeg a little bit. So, I used a grinder to shave off the upper part of the spring hanging point to increase the amount of tilt, but it still only goes up a little as shown in the photo.
Well, it is Universal's Made in USA product, so some modification is acceptable.
The effect when you ride it, however, is that it bites firmly to the foot! But there are no negatives of too much bite, and the best part is that it is easy to apply load on climbs!
I thought it was a bit expensive, but it was the right decision!
View detail
Fits: BMW G450X, GASGAS EC, GASGAS MC, GASGAS XC, HONDA CR125, HONDA CR250, HONDA CR500, KAWASAKI KX125, KAWASAKI KX250, SUZUKI RM125, SUZUKI RM250, YAMAHA WR250F, YAMAHA WR250R, YAMAHA WR250X, YAMAHA WR450F, YAMAHA YZ125, YAMAHA YZ125X, YAMAHA YZ250, YAMAHA YZ250F, YAMAHA YZ250X
This is awesome.
The specs are on the product page, so I won't go into too much detail, but one thing I have found is that it has definitely changed the Riding. As the product description says, it can be installed in various ways. I use it for WEX, JNCC, JEC, practicing on the riverbanks, and Motocross course driving. I use STDPosition, 2 washers are inserted for the start, 10mm screws for the front and middle rows, and 12mm screws for the rear rows only. I don't know if I will change it in the future, but it will be fun to experiment with it. View detail