- Home
- Product reviews
- Search reviews
Reviews
Too cost-effective, but if you want to use RightSide Stand, is it possible?
It was somewhat cheaper on Outlet and
I use this GCraft Side Stand, so I had an extra OEMSide Stand to Order!
The RightSide Stand is a good fit for the CT110 HUNTER CUB & omega;
The product itself is Black PaintingSteel and can be installed with no problems and no dimensional deviations
One point is that it is easier to position the Footpeg Mounting Bolt by pulling out three bolts, loosening one bolt until it is just about to come off, and then temporarily tightening one bracket and collar before removing the bolt.
Collars are long collars on the front two sides of the body
The two back side of the car body are fastened with short collars
If you are diverting an OEMSide Stand as we do
The screw groove cut at the back of the Side Stand must be penetrated with a Φ10 steel drill.
Was the GCraft made without Screw grooves?
When we changed the LeftSide Stand, I think we were able to go straight to the LeftSide Stand, but we don't care about irreversible processing, so we just quickly changed the Drilling
Easy to install outside as long as the hole is widened
It's a long-awaited RightSide Stand conversion.
Because of Left Side traffic, there are quite a few situations where LeftSide Stand is difficult to produce because of the Left slope.
I think the opportunities for use are there.
View detail