Good sound

I installed it myself
Unlike the Slip-on Silencer of Big bike, for example, the KLX230SM requires a lot of work to remove the Seat and Cowl.

The gasket is not attached to the exhaust pipe side, but to the exhaust system side, so it is difficult to remove the gasket and use it again.

Once again, I went to my local Motorcycle Supplies to procure them.

I like the sound quality, with a crisp, single-shot Motorcycle sound. The volume is a little louder than I expected.

p.s
For reference, SEROW can easily replace the exhaust system on the same off car. View detail

Used for KLX230SM

Silencer is lighter and feels lighter to handle.
I prefer the sound quality to be bass-heavy … View detail

A little less horsepower?

The sound is a bit loud with a pattering feel. I thought it would be a little lower pitched but I'm a little disappointed. Installation was easy. I also feel like I lost a little bit of Torque. View detail

Delta barrel4-S

It was a good buy, despite the pros and cons. View detail

Delta barrel 4s

A really good silencer, not too laud not to silent fitment was easy and fast i am really happy with the silencer i really recomend it! View detail

I can't recommend it without giving it away, but you can feel the lightness.

[How is it used?
Gap forest road and mountain play

Was the one you received as per Image?
I had done my homework, but it was a lot smaller and lighter than I thought it would be (which is good because that was my goal).

Was the installation difficult?
The installation itself is not difficult, but there is BALI etc. inside the place where the insertion is originally tight.
I lightly treated it and hit it with plastic hammers to finally get it in the right position.
It's inexpensive and I personally find this level of work acceptable.

How was your experience with it?
Purchased with the expectation of weight reduction. The effect is as expected and you can feel the lightness around the rear anyway.
You can't tell much on the open road, but on Dirt you can feel the lightness.
It seems to be a little easier to turn at high rpm, but the difference is only about the same as Brush-Bo.
However, I don't feel that Torque has lost any weight, so I'm satisfied for weight reduction purposes.

[Was there anything that disappointed you?
I'm not happy with the sound quality, although I knew that.
The volume itself is not so much, but anyway the bursting sound is terrible and grating.
I had done a lot of research on Net beforehand and extended Baffle's Pipe by about 4cm.
This eliminates exhaust interference at the tail and lowers the volume to almost the same level as NORMAL.
In addition, the sound quality has been improved to a Gentle sound with a little more low-mid range than NORMAL.

Apart from the above, we also found some serious defects in the product.
The Restrictor is sandwiched between the Tail cone and the Silencer body.
The gap there is too Large and the Restrictor is not fixed.
So after a few dozen kilos, the spot welds on the Restrictor came off and it started to act up inside.
I put in an Objection to Manufacturer and got it replaced, but the replacement is in the same condition.
Not sure if it's a design phase issue or a ROD issue.
After you buy it, you need to check it and fill the gap with Washeretc. if there are many gaps.

Because of the dimensional tolerances and BALI problems during installation, the above weld peeling problems, etc.
Unfortunately, I can't recommend this product to anyone who doesn't have a certain amount of work sKill.
However, since it is the lightest Silencer currently on the market
I think it is a good product if you buy it knowing the above defects. View detail