- Home
- Product reviews
- Search reviews
Reviews
This is the only exhaust manifold that exists.
I ordered this to replace my VERSYS exhaust manifold.
When I checked, there are only three companies, Ornish HeatMagic or Delke Big.
I really wanted BEET to release it, but when I asked, they said they had no plans to make it.
To be honest, I decided to go with Ornish HeatMagic because it is expensive and Delke Big is poorly made.
Installation was a bit labor intensive.
Instruction Manual is translated (not to be typed here, so it is installed with pictures and English text.
The Spring that attaches to the Flange of the exhaust manifold is quite troublesome.
Later, when removing the OEM exhaust manifold during the work, it cannot be removed with the Center Stand.
It would be better to use Side Stand.
If you have some work experience, it will take about 1~2 hours to remove the OEM and do this one.
In fact, the instruction manual says that OEM rear pieces can be attached, so it seems possible to attach a Slip-on Silencer from another company.
I connected a BEET Slip-on Silencer.
The volume was honestly not explosive with this combination.
It was about the same level as the Japanese Vehicle Inspection Correspondence vehicles running around the area.
Personally, I think this is fine.
I was wondering if more volume would cause increased vibration and heat exhaust, which would result in a loss of comfort.
It sounds a little panicky.
It just smells raw Gas.
Because the catalyst will be lost.
Please note that this is not a Japanese Vehicle Inspection Correspondence.
View detail