Reviews
Satisfied with windproof performance
Purchased because my hands get cold when the wind blows and it is hard to drive.
Since it is model-specific, installation was easy without modification.
View detail
For winter protection!
The product is very good, as it is compatible with the car model. I bought this product to protect my car from the cold in winter, and it works great and I don't need the electric heating gloves. View detail
GUYRA Gauntlet combines practicality and artistry
First of all, the windproof effect is quite high and it looks Large sturdy with spring/summer gloves until we hit midwinter! (Grip heater is on though).
No shaking or bracket gapping at high speeds, so you can concentrate on driving with peace of mind!
As for the installation, as explained above, you only need to tighten the Mirror Bracket, so if it is a Normal mirror, it can be installed with perfect clearance without interfering with the Accelerator Wire and Clutch!
I am wearing YOSHIMURA's Smoke Screen, and I think it matches well with the Smoke Screen and has a high dress-up effect.
I use a sv650 for work, so I was wondering what to do to protect it especially in the middle of winter. I know that the combination of a Handlebar Cover and Grip heater is the best, but it lacks a little in appearance and operability, so when I found the GUYRA Gauntlet, I bought it immediately.
If you are wondering about purchasing the product, I am sure you will be glad you installed it.
View detail
Performance is adequate.
I bought it for winter protection in the Kanto area and never froze when used with winter Gloves, which are not that thick.
Installation is also easy, as long as the RightMirror is co-tightened with the Mirror and the RightMirror has an Opposite Thread Screw.
The Bracket is solid and the Screen is strong enough to touch.
As is the fate of the SR400, the engine vibration is fine but shaky.
View detail
It seems to be easy touring in winter.
Installation was easy
But you need to adjust the Mirror after installation, because the Opposite Thread ScrewSpec. is Large ?.
View detail
For cold wind protection.
I bought it because I could not stand the strongest cold wave. When I put it on, it didn't look as bad as I thought it would, and I was more than satisfied with the Large effect. The cold wind hitting the fist is reduced, and I think that this is Large sturdy even without Grip heater. It is easy to install and remove, so I recommend it to riders who ride in the middle of winter. View detail
The wind will cut it off.
It is a necessity in the middle of winter, but it cannot be surpassed by this alone. After that, Grip heater installation. Still cold, Komine electric heat Gloves device. It's still cold. It looks like the image of the armor. But I can't repair the damage if I stumble on it. If you buy the AcrylicGuard part cheaply, you may be able to fit it to any type of armor. However, in winter, in order to change into Long Screen of SEA BASSOEM Product, if you cut all the Handlebar as much as possible, it will hit Screen. You may need longer bolts to remove the Handlebar and fit it back in. Also, please make sure to periodically retighten the Acrylic and Handlebar parts to prevent them from coming loose. View detail
It needed some modifications!
Handlebar, Mirror, etc... not OEM, so it interferes with things a bit So I tried to add the Nut and it became good However, the Screen [Color] It's Smoke [Color] I bought Clear [Color] I repurchased Smoke View detail
Cooler than I thought
Motive for purchasing
Around November, that it's getting colder, you should try it from around! And more than one person recommended it to me Well, let's give it a try! And I decided to buy it on the spur of the moment!
It's a little bit expensive for what it is, but I thought it would be nice not to spoil its appearance I decided to buy it
Good points
All season glovesQuantity without Inner Gloves, even in the middle of winter:1pc. and I can stand it! (In Tokyo's 23 wards)
It is not that it is not cold, but there is a feeling that the wind is prevented for Large, and the cold of the hand has eased considerably!
It looks even better than I thought it would, and it's starting to look better and better Parenthesis!
The sticker by CHIC DESIGN that is included with the product is also very nice Parenthesis is good!
What I liked about it
Not particularly
The waiting period for my order has been longer than I expected, so next time I'll be able to order something like this I decided to buy the seasonal items early
Installation difficulty
Brake Side is easy to install as you only have to put the Bolt1 pc on it I was able to do it, but I removed the Clutch Side once, and from the back ScrewQuantity:The process of removing the 2pcBolt1 pc was a bit more complicated than I thought it would be, as I had to remove it It was
View detail
My fingertips are windless
Obviously, there's less wind hitting my fingertips, and there's almost no wind in the experience
With the outer lower end curved and replaced with our BEET's Handlebar It's completely guarded, but if you're the one who holds the end of the Grip in the OEMHandlebar Small The area around the finger seems to hit the wind
In order not to run in conjunction with the Mirror, the hollow of the bracket is replaced by the Screw of the Lever holder but I felt the depressions should have been a little narrower because there was a lot of play
View detail
Buy with no loss
[Was there anything that disappointed you?
Nothing special Generally in line with expectations
Do you have any wishes or improvements you would like to make for the Manufacturer?
Currently [Color] With Clear [Color] There are two types of Smoke, but I'd like to see them come in darker colors like DARK
[Do you have any products to compare it to?
Daytona products, I quit because they weren't exclusive products
Frequently Asked Items
What made you decide to buy?
That it was sold as an exclusive product; GUYRA Gauntlet's Naming is cool! (^^) A friend of mine was using a different type, but when I heard that it was very effective, I decided to buy it
How was your experience with it?
The effect is more obvious as the speed increases
If the wind is 10 when you don't have anything on, the windproofing effect is about 80% of the experience, and also after rain The Gloves are less wet and have a definite effect
In my case, I'm trying to fit it in the Handlebar End as much as possible without worrying about it If you put it on, you'll get a much higher wind protection
Was the installation difficult?
Installation is easy by tightening with the Mirror In addition, since the stopper comes out of the mounting bracket for the prevention of circumference, you can use it within the range of motion Can be fitted with a Snap
【Please tell me the installation point and hang】
Please hold down the Mirror by hand to avoid gapping
[Was the Instruction Manual easy to understand?
Yes, it's easy to understand
[Included Parts:were they on?
None
[Others]
It is windproof and has a certain amount of protection from the cold, but when stopped, Quantity:Pair (for Left and Right) The wind from the air is affected by the temperature of the outside air
It's not a good idea to be bought in the same sense as the Handlebar Cover, etc
View detail
Guyra Gauntlet
Excellent quality, very strong and dense material. Installation takes very little time, technically simple. Excellent quality, very strong and dense material. Installation takes very little time, it is technically simple. translated by Google Translator View detail
It does not fit in Long Screen
I also searched on Long Screen whether or not it searches I did not see any clear answer, but I seemed to be looking, so I tried to purchase, anxiety hit me, I interfere with Screen, sleeping in the warehouse View detail
Fits: HONDA NC750S Dual clutch transmission, HONDA NC700S
Just like OEM Product
Although similar things are out of many Manufacturers, it is a common part that I see often, but perhaps it is the best one. Function, installation method, quality of Body, I think that everything is fine. The only disappointing thing is that the Reverse side of the installation Bolt is exposed so it looks bad. Some people may not be bothered, but I could not forgive, so I decided to use Universal Product Material : Plastic Cover bolt purchased and attached. View detail
It is recommended
It was very good to use for NC 700X, so I purchased it for third generation 2016 type NC 750S although it was not included in the compatible model.
If you were prepared for some modification, there was nothing, it took about 10 minutes with a pon attachment. This product, which is quite expensive, I think that there are also many people who can not be ready to purchase if they are not included in the compatible vehicle type List. Manufacturer, there is no business.
As shown in the photo Simple construction makes installation easy to work together with Back Mirror. Moreover, it can be attached firmly.
Unlike for Off-Road, the rectifying effect on the upper part of Handlebar is high, and wind and rain does not come from cuffs. It also covers the Clutch Wire part where rain and dust easily enter.
In the winter, thanks to windbreak effects, cheap Winter Gloves never freezes like it hurts your hands.
In the case of my choice Clear type, I do not feel much to wear, so I am honored that it does not damage the neat feel of Naked motorcycle.
One thing that is worrisome is Quantity which fixes Polycarbonate Body and iron Bracket : Since 2 pc Stainless bolt Nut has no locking prevention, apply locking material, put Spring Washer, exchange with M6's loosening Nylon nut etc. etc. It seems better to take countermeasures. I chose Nylon nut.
I sell various Knuckle guards, but I personally think that this is the best.
View detail
It was subtle.
I installed in XSR 900.
I installed it in wind protection main in winter, but the coldness of hand got relieved somewhat.
Bracket is holding and the circumference of Handlebar gets messed up.
The shape of Bracket is not good
It was not satisfactory to join MirrorNut together..
The price is also a bit high.
Currently undone.
View detail
I think that shape, Large Kimono etc..
I ran the highway at the end of the year and I could not stand the coldness of my fingertips so much.
After installation, I can not run with cold Timing but there is a feeling that the wind is not hit.
View detail
Windproof - Effective for cold weather
Commuting CB 750 (RC42) I installed it on, but the wetness of Gloves at the time of rain certainly decreased.
Because the normal winter gloves kept the warmth sufficient enough for touring roundtrip 250 km, so windproof - I think that the effect of cold weather is high. Easy to windbreak position with Bracket of vehicle type Exclusive Design - Considering that it can be mounted securely and taking into consideration the fact that it is larger than the Universal Product, I think Cost performance is high.
View detail
Impression over the winter
Purchased in December 2015. Used in 2003 type XJR 1300.
The area around Handlebar remains OEM. Is the attached handwritten style Illustration?
Attached Instruction Manual wear after reading. Do not scratch with Lever,
I installed it but it takes less than 30 minutes to complete.
I used it with Yamaha OEMGrip heater.
It is the result of using the outside temperature less than 10 degrees ~ 0 degrees,
Since we have poor circulation of fingertips, with the heat of Heater alone,
Although it is uneasy even in cold weather in spring,
Since the running wind does not hit the fingers and goes upward from the elbow,
It was very nice that my fingers did not get caught.
Also, Gloves is hard to get wet with Touring in rain,
It was very useful. From time to time,
It is enough to tighten it upright by vibration or not.
View detail
Fairly satisfied
I knew Handlebar Cover's cold and rainproof effect well, but I did not attach Silhouette with Cover on both ends of Handlebar because it looks awkward. This product is more transparent than I imagined, it does not insist so much even if it is attached, the installation method is also very simple. It is good to Cover the Wire exposed part of Brake lever.
The only disadvantage of the only Large is that when you attach the HondaOEMLong Screen you can not hit the Screen and completely disconnect the Handlebar, as well as you can not use the Handlebar Lock. Other Manufacturer's Screen may have the same trouble.
Because GUYRA Gauntlet was more important to me, I switched Long Screen back to NORMAL. I think it's a good product.
View detail