I put it on an upright Fork.

[How is it used?
After purchasing XG250 TRICKER, I found this product when I was searching for Fork Boots while I was customizing ChocolateChocolate to my mountain play spec.
Well, I somehow know that I can't go wrong if I buy SiliconFork Boots made by DRC... I'd like to change the look a little bit." I found Fork sealSkin at that time, and chose the color Black as a safe choice.
Was the one you received as per Image?
This product is made of NeopreneMaterial, which is also used in Suitetc. for ScubaDiving. The fabric is soft and thick, and it protects foreign objects from entering the oil seal part even when running through small stones or muddy mud. The product was exactly as shown in the Image.
Was the installation difficult?
Since it is a Velcro (Magic tape) type, simply wrap it around the front fork and fasten it with Magic tape.
It takes a little bit of hang to keep it looking good, but if you don't mind, it's really "Just roll" If you wrap it around an upright Type Fork, you don't even need a Tie Band.
How was your experience with it?
It inhibits the movement of the Front fork." I could not tell the difference between the Fork Boots and the normal Fork Boots because the Fork on the vehicle I used was not delicate.
It can be easily removed even if it gets dirty, and dirt can be kept from entering the inner tube, making it convenient for maintenance and car washing.
[Included Parts:were they on?
Product Body only.
[Was there anything that disappointed you?
Above. How was your experience with it? This is all that is stated in the following section.
Other items that would be helpful
Point and hang of installation
Just wrap it around the desired location and fasten it with Magic tape." This is a super easy job for
[Availability and clarity of the Instruction Manual
I don't think there was an Instruction Manual.
[Notes]
There is nothing special about this either. In the unlikely event that the Fork is too thick to reach, check carefully the Size of this product and the size of the vehicle in which you wish to install it.
[ITEMS TO BUY TOGETHER
This product can function on its own, so there is no need for additional products.
If you are on a budget, you may want to purchase some dress-up parts and functional products such as short lever and grips.
[Opinions and requests to Manufacturer
We look forward to your continued patronage of our various product lineups. View detail

Used for Motocrosser

No more oil leaks from stepping stones or sand bites, even Muddy doesn't get in. However, it is obvious that the suspension movement becomes worse. I guess it is up to the rider to decide which one he/she prefers. View detail

I was in a sludge.

I got a little sloppy, so I'm posting a picture.
It's nice to have mud protection around the Seal. View detail

Effective

The yz125's OEM Fork Guard is open on the top side, but it saved me from a rocky fall where I might have gotten some damage if a rock had hit me directly. I'm not expecting that much protection, but I'm lucky to have it rather than not having it. View detail

Is this enough to make a seal last longer?

It is not strong, but it is very effective.
Put them on only when you run. If you do, don't forget to clean it. View detail

To protect the Oil seal from Muddy and Sand

I use it on my Muddy and Sand Race to prevent chewing into the Oil seal. It is easy to install, just wrap the Fork around and fasten with the in Hemp palm. I felt that the effect of preventing the intrusion of soil and sand is sufficient. On the other hand, the way I installed it was not good, a small hole opened up after two uses (no problem to use). I think it is good to use it after checking whether it interferes with the Outer Tube Guard by installation. View detail

Effective

After installation, I went for a run in the woods.
I installed it without the Tie Wrap and it did a good job of keeping the dust out.
The only problem was that I put it on without a Tie Wrap and there was a small stone in the gap between the fabric and the fork. (It was on the top, away from the seal, so it wasn't a problem.
So you may want to use a Tie Wrap to hold the top in place.
Naturally, it is advisable to install the Oil Leak Seal before it is damaged.
It's easy to install, but the Magic tape part is a bit cumbersome to pull and adjust.
Totally, I think it is one of the useful equipment of Off-road car. View detail

For Inner Tube protection.

I used it for YZ250FX.

The FFork is prone to Oil leaks rather frequently, so I bought this to give it a little protection.

Installation is very easy, just wrap the FFork with Surface Fastener and secure with Tie Band.
It is installed across the Outer tube and Inner tube.
However, because the entire Cover is made with almost the same width, the Inner side has too much Cover and the Outer side has not enough Cover relatively.
I thought a little that I wanted to change the width of the Inner side and Outer side instead of all the same width.
Maybe that's the only way to make it universal.

As the Cover is applied to the Inner Tube. Wouldn't that adversely affect the suspension's operability? Strictly speaking, it may have an effect on the absorption of small vibrations such as when stepping on a small stone, but I could hardly tell with Level.
However, if the lower edge of the cover hits the under bracket of the fork at full bottom, it may affect the cushioning more than normal, but since the surface shock is larger, I couldn't tell at Level.
By the way, I only install it at EDCourse and remove it at MXCourse.

When I wash my car, I don't want to leave the seal of Fork covered with wet Cover, so I remove it after washing my car.

As for durability, I think that durability is high because it is still active though there is a tear at the time of a fall etc. and it is getting tired considerably after using it for almost 10 years. View detail

I just put it on.

I had a FrontFOil leak on the Left Side when I went out on the grass race with my WR250F.
I asked the shop to change the Fork oil and installed it so that Garbage and mud don't get into the Seal.
It's very easy to install, just fasten with Magic Tape and tie with the included Tie Wrap.
Are you really going to tie up the top of Fork's hump? I'm tying up the cob, but I don't think it's a problem.
We'll see how it goes for a while, but if you don't like it, just take it off, so I'll give it a try.
View detail

It's comforting

Installation is easy with the Surface Fastener, but I'm assuming a bit thicker Fork You're there, or the KLX150 has a surplus of Surface Fastener, depending on your orientation Interference with Fork Guard

If you're a person who gets sloppy off-road, I think you should put it on if you're a person who gets sloppy off-road It's comforting because it's so much better without it It's just something Fashion

I don't use the attached Tie Wrap because I often remove it after playing off-road because I wash the car Because there is a gap between Fork outer and this product at the upper part of the car, it can be removed from there Sand goes in
This product dries rather quickly even when wet, so if you wash and dry it before washing the car, it will be dry after washing the car
View detail

One word of wonderful

Oil was leaking from the fork at the last time of Enduro run in Dry After installing this product in preparation for Muddy, I participated in the race
The results are as you can see in the first and second photos
I didn't remove and wash the second picture, I used Tie Wrap to Firmly tighten the top
No mud ingress, it works View detail

I worked hard for one and a half years!

I ran for a year and a half like a galley place and so I used it hard so I used to gap a couple of times but did a good job. Since it is already torn and it is tattered, I will replace it with a new one, in use, there are no scratches on the Guard part, Oil leakage, it is perfect. View detail

Required Items

It also attached this to the previous Motorcycle and demonstrated its function to the end.
When it gets dirty it's enough to wash and durability is perfect

The installation is Magic tape, but it will not come to Gap if you do it without any gaps
I do not use the attached Tying Band. View detail

Protection of inverted Inner Tube

I think people who run Off are essential. Fork Guard alone can not prevent dirt at all.
By protecting the sliding surface of Inner Tube, Damage of Seal is considerably reduced.
Although the installation itself is simple, since it only took about 5 mm to the Outer, I felt unreliable only with Tying Band, I gently pinched it with Fork Guard Guide.
As there is 20 cm on the Inner Tube there is something like a full bottom 30 cm sometimes sinks and I think that 10 cm longer would be better personally.
Invert Spec. There is a sense of security enough to think that it can be attached to Standard on the Off car.
This Recommendation. View detail

very good.

Not limited to Inverted Front Fork, Sealetc. It is very effective in preventing scratches caused by dust and dirt. Just fasten the installation with Magic tape, Fit it enough without stopping with the attached Tie Wrap.

I will not let the earth and dust at all on the side of the effect, I inspected after traveling, but very Fork was beautiful.

I think that it is a very satisfactory product and I think COSPA is good on my own. View detail

Purchasing wishing for long-lasting Fork seal.

Because it is Magic tape, it can be easily wound and removed. I just got it, so I do not know the performance, but I am painting Front Fork Grease and rolling it I think Smooth is the behavior.

When exposed, when ForkGrease is painted, I was in trouble because I stick Garbage, but because there is Cover, that amount will be less.

Tie wrap tightening is easy - - - Was not there any other way?

When I enter the forest road and become a muddy, I'm looking forward to seeing how active it is.
I made it to Blue according to the color of my WR (The current GraphicSticker is also Blue type) I made it to this color, but I like it quite well.

I am thinking of buying SealSkin of Rear suspension. View detail

Firmly Guard

He firmly guards Seal of Front fork. Sometimes I remove it and polish Front fork, but I do not involve any mud etc.. Just stop by Velcro is uneasy so I stop with Tie Wrap but if there is something better way to do it View detail

Seal protection of Front fork

It is a horrible and easy installation that fixes with Velcro and fixes the upper part with Tie Wrap.
Working time is also extremely small.

As it is easy to clean, I think that it is better to remove it regularly and clean it.
As of now, there are no plans to assault you where you will take care of, but at the bottom of SealSkin you will see mud etc etc. It is expected to improve the life of the Fork seal as it is a form to cut away.

MaintenanceCycle has never been over long, so I wondered if it will be damaged. View detail

No mixing of mud

Enduro We have been competing for 10 races a year, but due to the inclusion of mud, we had exchanged Fork seal one or two times Season. I bought a product for half a year, but it did not contain any mud.
It's easy to install, has a Design Color and is Recommendation. View detail

Front fork oil seal lives longer

Mad and dry and active on days with many dust.

Installation is Tie Wrap, so it's easy.

You can use it many times if you remove it regularly and wash it.

Although I made my own by imitating this product before, it is better not to compare the durability and appearance, if it is this price it is better to buy.
It's fairly Large strange when it's my own work. Sewing Magic tape.

Suspension is an expensive and important part to Motocrosser.
There is nothing better to last for a little, so please install it. View detail