ODAX Keiti Fuel Cap Pad

연료통 입구에 흠집이 나는걸 방지해 주려고 샀습니다.
푹신푹신한 재질이라 더 좋은거 같아요
스티커만 붙이면 되는거라 설치하기 간편합니다.

I bought it to prevent scratches at the entrance of the fuel tank.
I think it's better because it's a soft material
It's easy to install because you just need to put on a sticker. ---------------------------------------------------------- I bought it to prevent scratches at the entrance of the fuel tank. I think it's better because it's soft and fluffy You only need to attach a sticker, so it's easy to install. I boughHt it to prevent scratches at the enterance of the fuel tank. I Think It'S BECAUSE IT A SOFT MATERIAL It's Easy to Install Because You Just need to put on a Sticker. Powered by Google Translator View detail

I got air bubbles.

Maybe it's because it's transparent, or maybe I was too bad at applying it for the first time, but the air bubbles are very noticeable!
I'm glad I don't have to worry about Zip wounds anymore! View detail

Puas sekali dengan pelayanannya, barang memang benar2 original, sabar menunggu karena barang memang dikirim dari negara tetangga, part2 built up cukup lengkap di sini. Dan saya ingin mengusulkan yaitu parts untuk Honda Nice 125 segera disediakan View detail

FOR CB250F

Actually this item i could not found in my country (DUST SEAL (22X42X7) (ARAI) 91252-MC7-003). Finally I bought it from webike. It is genuine. Very good packaging.fast shipping. Thanks to the webike team. It has not been installed yet.good for the genuine buyers.highly recomended. View detail

Puas sekali dengan pelayanannya, barang memang benar2 original, sabar menunggu karena barang memang dikirim dari negara tetangga, part2 built up cukup lengkap di sini. Hanya 1 kekuranganny yaitu parts untuk Honda Nice 125 tidak bisa di pesan. View detail

Puas sekali dengan pelayanannya, barang memang benar2 original, sabar menunggu karena barang memang dikirim dari negara tetangga, part2 built up cukup lengkap di sini. Dan saya ingin mengusulkan yaitu parts untuk Honda Nice 125 segera disediakan View detail

Grip heater refill

I installed a replacement GH-10 that I had been using for 2 years, but it stopped working and during a Sale.
I was thinking of using something different, something made by DAYTONA or something with a separate controller, but I chose the GH-10 again because I thought the convenience of being able to operate it with a short push at hand could not be compensated for by the difference in price.
The Axel side is easy to install since it is integrated with the Throttle cone. The opposite side is difficult to install unless it is warmed up. Wiring is done by floating the Headlight in the back gap. It's still useful to have it from a little chilly season to winter. View detail

Other Brand Product

Purchased in lieu of OEM Parts.

Which would be less expensive?

Functionality is fine.

Installation requires a hang.
Manual would be useful.

If you make a mistake, oil will leak.
Your attention, please. View detail

It's very conspicuous...

Nomal black caps with pinch points are tacky.... View detail

Defective item

It was a molding defect with a tumor-like bump inside.
I had no time to return or exchange the product, so I had to go through a lot of trouble to remove the bump and install it, but I was disappointed with the quality of the product, which was less than Chinese for the good gold price. View detail

Add on to Clamp on heated grips

Best bang for your buck, works ok, and i like it works/plugs in with clamp on heated grips! I have good luck with most all webike products. I purchased 1 of these along with the associated heated lock grips for my wife's and my bikes. Installation was straight forward after watching the videos. Just had a chance to try them out over winter break with temps around 10C - 15C. They took a few minutes to warm up, but did a great job. We typically started on a setting of 2 - 3, then turned them off after our riding activity increased. Very warm, even through our winter gloves. Great purchase, happy wife!Would recommend! Fast shipping as always too.Thank you Webike. View detail

Easy to install, better than ManufacturerOEM

The switch is integrated with the grips for easy installation, requiring only wiring and no effort.
It is also possible to point it straight up to avoid touching it when operating the blinker. If you warm up the Heater to the maximum Large setting, you can easily pull out the Grip.
The thickness is just right for general OEMSize and is a non-slip Material. View detail

To be used for DTRACKER125

I plan to use it for the next oil change of my DTRACKER125. It is a commuter motorcycle and I replace the oil every 2000 km, and I replace the filter every two times. View detail

Can be used without problems

I think it is not cosmetic, but it is normal. The luggage Hook is so hard to use. View detail

More convenient to add accessories

This short clamp really added flexibility to add accessories. With a wide variety of accessories that is able to mount on this clamp, i now have more options to make my bike more practical and functional. It is easy to install, tip is make sure you label/mark the original master cylinder location so that when you mount it back, it will be on the same original position. As you can see from my image, i used this clamp to install a hazard switch & a USB-C charger+voltmeter. View detail

very good. This is excellent in finish and quality

There were many subsidiary materials, so there was no difficulty in installing them, and I personally think the LED light is beautiful I'm willing to install it on my other bike. View detail

Puas sekali dengan pelayanannya, barang memang benar2 original, sabar menunggu karena barang memang dikirim dari negara tetangga, part2 built up cukup lengkap di sini. Hanya 1 kekuranganny yaitu parts untuk Honda Nice 125 tidak bisa di pesan. View detail

Cospa is good

Smartphone Holder is using RAM Mount.
This type is the best looking and the best way to fix it without getting in the way, so I use this type for all my motorcycles. View detail

Required in winter!

It has been 3 months since I installed the Grip heater on my NC750X and the day to use the Grip heater has arrived. The warmth is not a problem, but the Horn is above the blinker on Honda cars, so the blinker is not easy to operate with winter gloves. Since we did not expect to use Winter Gloves when we installed the Grip, we had to change the position of the Grip in a hurry. Even after changing the position, the connectors on the Grip heater are still in the way (especially when turning right) and the operation is not easy. You may get used to it, but please be careful if you drive a Honda car. View detail

Already the third one.

Every time I change motorcycles, I install a new grip heater, but this heater is the only one I use. The heater remembers the last Level, so it keeps the temperature at the right level. View detail