- Home
- Product reviews
- Search reviews
Reviews
For Blowby hoseSize conversion
I ordered a KIJIMA product that can be used to change the size and routing of a blowby hose.
Durability is just the beginning.
View detail
Not only for Motorcycle, but also for four-wheeled vehicles.
Love car FZr1000 Surprisingly, I used it for my four-wheeled love car 12SR.
Blowby measures.
6mm → 9/10mm conversion is a well used Size.
I bought this product because it was the only one that was L-shaped.
The video shows the acceleration of the CR12DE engine which is in good condition.
View detail
Due to the depletion of OEM parts …
If you drive an old car, one thing you can't avoid is the end-of-life of OEM parts You can still get parts that are not related to driving, but you can even get parts that will be undrivable if one goes bad Even though it's not going away, it's a part of our daily struggle
In my case, the Fuel Hose, which is attached and detached every time it is serviced, has deteriorated over the years and has become stiff and hard to avoid Gasoline leaked, and Fuel Hose is any oil/weather resistant Hose It looks like a good thing, but Racer replica, which has started to focus on mass centralization, is a good thing around here The design is also Limit, with intricate curved lines running through the Frame I am Hats off to the designers at the time, but it's a tough sell when these specialized parts are discontinued Even if Universal's Fuel Hose is used as it is, it will be difficult to use Gasoline's There is a risk of running out of supply or tearing while driving due to unreasonable bending of the Stress This is where the L-joint is needed
There are not many L-shaped hose joints with 10mm inside diameter that you can choose from, and they look messy when you put them on Honestly, I didn't want to use it too much, but I can't whine about it because it makes it impossible to run No I've only tested it for a few dozen kilometers, but so far, I've been able to find a gasoline leak and a flow rate of I don't feel a shortage The only thing I didn't like was the looks, which was a far cry from the old Ka Chica Chi Hose The supply of parts for old cars is getting tighter and tighter every year, but it's safe to say that we can extend the life of the car with some ingenuity like this! I have done By the way, the inner and outer diameter of the Horse may shrink with age, and may differ from the actual measured value Please be careful when you do so
View detail
An 8-mm Size was purchased.I think that I will purchase it next time also since the problem is an article which is satisfactory at all although it is which did not exist and which can just be regarded as somewhat larger than an 8-mm Size for the
An 8-mm Size was purchased.I think that I will purchase it next time also since the problem is an article which is satisfactory at all although it is
which did not exist and which can just be regarded as somewhat larger than an 8-mm Size for the
article itself.
View detail
I purchased for uniting two hoses. Although it is a simple connector, it would be troubled if there is nothing. Although Y type and T type are also required, of course, I think it would be convenient if there is two parallel exits like a tuning fork.
I purchased for uniting two hoses. Although it is a simple connector, it would be troubled if there is nothing. Although Y type and T type are also required, of course, I think it would be convenient if there is two parallel exits like a tuning fork. View detail
It purchased in order to attach the sub tank of G craft. Since it was goods currently recommended by the manufacturer, it did not waver.
It purchased in order to attach the sub tank of G craft.
Since it was goods currently recommended by the manufacturer, it did not waver.
View detail