Reviews
Used in wr250x
Fork was pushed out to the limit, Rear was shortened to the limit at the ride height adjustment section, and even with -20mmSeat of db’s, it was quite Limit for 149cm to ride, but LINK was also Quantity at the lowest state.:Set and it gave me a little more room, so if you're worried about footing, I'd recommend it!
However, if you lower it that far, the Side Stand will be too long and the Motorcycle will stand upright, so the recommendation is to use a STANDCut or ZETA aluminum side stand with a -15mm tip!
View detail
It was exactly what I expected
The design is good and the product is as expected? (^-^) /?
I recommend it to everyone
I bought it to improve its footprint, and I'm sure it will achieve its purpose and give you peace of mind from now on You can drive
View detail
good
I bought them to improve my footing and I'm happy with the Potential as I expected
Before, he was seated in Seat with his feet in a very splayed out position, but his feet are just his toes
It's on the ground, so you can enjoy driving in peace? (^-^) /?
View detail
Fits: HONDA CRF250L, HONDA CRF250L LD, HONDA CRF250RALLY LD
If fine adjustment within 25 mm is necessary
I installed it on the CRF 250 M of MD 44, but Adjuster should be fixed with Tape etc. at the time of installation. When I tightened with Torque44Nm prescribed without noticing that I misaligned at the time of tightening, how swollens are !! (It is as shown in the picture) I broke the protrusions on the body side and broke the 20,000 LINK to par, but I could install it again. I thought using it, I wanted to lower the adjustment by 10 mm more, I was more rough and I did not need fine adjustment within 25 mm. If fine adjustment is unnecessary 5000 yen cheap Adjustment of Zeta None VERSION is good? But it is cool so it was good. View detail
Fits: HONDA CRF250L, HONDA CRF250L LD, HONDA CRF250RALLY LD
Ownership feeling, satisfaction feeling is different
OEMArm is actually looking Aluminum and it is surprisingly heavy with casting removed
First I am surprised by the lightweight feeling of the real aluminum.
Because Adjustable Dial is easy to fall, Recommendation is to temporarily fix the end with Masking tape.
As the weight will be reduced under Spring, the suspension movement improves Response
I feel like contributing to the Throttle response on Flat Galle Road.
I am 2 cm protrusion of Front fork and I like it very much that it can realize Lowdown according to it.
Although the Spring rate is decreasing due to the Lever ratio, I feel that ride quality is improving, I also like the movement of supple Arm.
Because it is a part that looks firm while stopping, Arm of Red alumite meets ownership feeling and you can see it when you see it finely AdjustableMemory is also CUTE with Me Snap C feeling full mark..
View detail
I bought it to improve the feet arrival of wr 250r.
In the past, I exchanged Spring back and forth, the car height at the time of riding fell down pretty, it did not splash softly, but still, I can not slip ass every time when stopping, sometimes it can run out of bad feet of getting on the descent I tried purchasing a product.
I thought it was good to make it as adjustment type because it gets softer than I thought would actually be installed.
When this is installed, the Side Stand is too long, either shortening or needing to replace the Side Stand for X.
View detail