- Home
- Product reviews
- Search reviews
Reviews
Used for TS200R OEMcarburetor
As the title suggests, it was used for the TS200R OEMcarburetor.
Actually, it is SEA BASSOEM Parts and it is discontinued.
They are not exactly the same, but they are completely compatible.
I believe a new replacement will restore performance.
View detail
It must be a P-0 Needle Jet, but …
It is true that Needle Jet's P-0." but there is no hole for the air breeder.
I bought it to install on my TM32SSCarburetor for RGV250γ (VJ22A), but it cannot be used as setting parts unless the holes for air breeder are drilled.
I think it would work for Mikuni TMCarburetor which uses without Air BreederType.
I should have asked and checked before purchasing. (My mistake)
I am extremely grateful that I can still get a new Jet made by Mikuni. Hopefully there is also an Airab Lead Type for the RGV250γ, which would be very helpful.
Star Quantity with the hope that the Airab Lead Type will also be available.:5pcs.
View detail
My Mihara TMX30 is getting old, so Needle Jet replacement!
TMX30 sold by Mihara is getting old.
I also replaced the inside of the Needle Jet tube as it wears out.
View detail
It certainly changed!
After second-hand TMR purchase it was dense at all openings so I bought Needle's Straight and Taper, I bought it dense ~. As you observed the Jet needle that was originally attached, it seemed like NYLLE JET wears out as it was a feeling that the straight portion is worn, so as expected and it was not changed so much with the new P-6 Purchase P-4. P - 6 After changing engine, if I put Engine on, it got thinner now, if I make Straight thinner the first time the air / fuel ratio becomes 14. 5th to 13th. Idling also changed to 11. 6th to 12th. Because it became 4th place, the effect is perfect! Needle Jet also wears out, so if you are getting sick, you may just switch to a new one, it's just expensive! View detail