Kembali ke atas

testtesttest Sonehara

I made this Filter the same as last time in the third Oil exchange.
Filter wrench is not required, there is no new expense, even in terms of performance
Since I could use it without problems, I would like to repeat it in the future.

Plug is changing in 2 to 3 years even if it is not in good condition unless it is irritable or high endurance. Indeed it is a start condition, from Idling to Red zone I ride well.

Although the same Besla 's Resin pad was installed close to a new article with almost no decrease, Fei Ring was bad for anything, and at the beginning Caliper and OEMMASTER pushed one after the other though I thought it was such a thing,
Even if Atari is not working as a trial, both braking performance and fee Ring have been upgraded to Large width. Dust is also less than Resin.

It is a Manufacturer that has a track record at Race in own production and can be trusted, so if you do run like a Sports run or a load as it is, it is a Recommendation.

We installed the MRA Screen on the W650, but purchased it as a measure against the coldness of the fingertip. I tried running for about 30 minutes when the maximum temperature was around 10 degrees, but I ran enough in summer Gloves.

I thought that it could be cheap at with Magnet, purchased, nothing was Paint on the exterior It was good at Simple
Since the tightening Torque is stated in the OEM, I watched it and installed it, but the next time I need to look it up
MT07 was 15 Nm

I have heard the reputation of this Plug, but I tried buying it to be handled by Webike.
So far as Watani's designation OEM DPR Gap 1. I adjusted it to 3 mm and used it. Ignition system and lighting and fans (Cause of voltage eating) And is completely processing Wiring is divided.
Even when I changed Igniter and Coil "Beauty is on fire" Although I was impressed with this, I will go further up when I put this in. The cloudy rush of about 5000 rpm from Clutch meat is like Silky, it seems that generations have gone lightly for about 10 years. I feel that my heart or exhaust smell has also decreased (Lol)
However, it is said that the introduction of Wotani SPll is the Large premise as minimum as Mr. Shimaba says from the import distributor. Horribly Gap is wide so fire will not fly in the same Coil.
If the fans turn around due to heavy traffic in the summer, there are many misfires → JR 8C installed, but ... If you want to enjoy drastic solutions and fine Feel, I recommend this combination.

Previously I used Puppy 's Handlebar Cover, but I felt bothersome on desorption and hand - operated operation I bought a WorldWalk Knuckle guard. It is also solidly made, windshield effect is high and it can respond to sudden rain all seasons seems to be used. Just when the temperature was below 5 degrees, I felt that long distances were hard even if there is Grip heater. A little more Reduction in cost It is a wonderful item that I think the number of users will increase if it can be done.

Hello. I bought this oil filter for my Yamaha YZF R1 2005. The package was well packaged, came, without any damage. The oil filter HIFLOFILTRO HF-303 was designed easily and without problems. The quality of the goods is as high as it should be. I will buy more. I recommend it to everyone. Do not regret that you buy it for your favorite motorcycle. I wish everyone good luck and success. Thank you .

It is my first exchange since I got on a new car. I am amazed by NORMALPad with about 30,000 km. Because I attached Red Pad with a different Motorcycle, I decided without comparing with others in particular. I feel that NORMAL's Rotor is bad, but it seems to be bad, but the credibility is better than NORMAL. I do not know Cost performance yet

Discovering the Spark plug that looks like the face on the product explanation screen of Wa Big who happens to be found. Regarding its use, this plug which encourages watani attachment to the ignition system. The purchase decided immediately for a car that meets the conditions! When looking at the real thing, Steel color which Blue took first gets an eye out. The center electrode of the tapping was NGK - Compared to DR8EA, it will be positioned more towards the center of the combustion chamber by 1 mm or more, which will increase expectations for combustion efficiency Up. However, looking at the details, I can not deny the feeling that it is more complicated to make than JAPAN's Plug. BALI of the center electrode and screw terminal type terminal are obviously off center. , I feel a little cheapness because I am watching JAPAN items with high precision from the usual. However, if you actually use it and have sufficient performance and durability, you can say that it is not necessary to request such parts that are not normally visible. I installed it immediately, but the exchange itself is exactly the same as regular Plug exchange and there is no particular problem. The accuracy of the Screw part seems to be a passing point. When I try to cover Plug cap, it is Fashion that Blue 's Steel color looks sharp. And Engine start! - - - That sounds exhaust sound from Mild something more than usual. Because it is a single cylinder, there is a place called Dododo, but it is called Toto. However, rather than being cheesy rather than luxurious - - -. Also, the warm exhaust gas Gas in the winter season has Gas smell, but it feels like it has been relaxed. Impression that Engine braking became Mild when I actually ran. I have stopped playing. Furthermore, Engine vibration seems to be decreasing. Since Cowl was wearing, engine oscillation was swaying the edge of Cowl, as it was Big Li after replacing the Plug, it became impossible to see it. It is feeling that the rise is also powerful though it is Mild. I am surprised that there is such a change with just one Plug. I ran about 20 kilometers, but I did not feel Minus factor. I would like to see the impact on fuel economy and the durability of the plug itself. It is limited to strong motorcycle of watani equipped car or ignition system, but it is recommended plug at the first impression.

OEMValve surprisingly deteriorated severely, I chose this product of Heat sinkType from Large change high performance using other Manufacturer's LED Bulb with other two wheels.
Although Rear's Rubber cover requires a little processing to install, it is not a big problem.
Since Heat sink is exposed under the Fender behind the heat dissipation in the summer, there is no Trouble.
Depending on Manufacturer, it was said that there is a problem with quality, but there is no such worry.
There is no problem with riding the light almost every day at work without problems.

Oil Filter is exchanged periodically, but performance is not problem at all.
Also, as long as it functions as a filter, Manufacturer thinks it is unnecessary to keep in mind.

I will tell you the feeling of use outdoors without a roof.
We are calling for less invasion of rainwater and I did not expect it until Completely Waterproof.
However, since it is a two-layer structure of outer material and lining, soaked rainwater enters between the layers, eventually the Motorcycle also gets wet to the bisho-basho.
In addition, the rainwater that enters does not dry easily because it does not touch the outside air or sunlight between the fabric and the fabric.
With this price at nearly 30,000 yen price, I regret very much that I purchased it.
With this, Che Che Co Cover was enough.
Those who think to use outdoors without a roof, I think that it is better not to be bought absolutely.
As I just started using it, I will review additional durability at a later date.

This is the second time we are wearing it, but it will start with Cell one shot. (It is natural because it is a new item) The engine is bad for a while and lastly
It was released from trouble because Starter was not used until it was not used. Opportunities to ride will also increase. After replacing the last Plug
I used it for 4 years. I will change it frequently this time.

'