Kembali ke atas

Since oil change time came, it purchases in order to also exchange filters simultaneously.
I wanted red ....

It exchanged together at the time of brake lever exchange.
I was easy to grasp lever form and thought that texture was also good considering a price.
A point regrettable [ one ] has GATA in a pivot part compared with a pure lever.
Operation does not seem to be affected.

It attaches above all and safe.
This No. 1

Blue color of Anodized is gathered up as Accent in the whole of BlackBase.
I use it together with MASTERSinterCap of the same series

I made this Filter the same as last time in the third Oil exchange.
Filter wrench is not required, there is no new expense, even in terms of performance
Since I could use it without problems, I would like to repeat it in the future.

I purchased Green Light because the installed Motorcycle is Z1000, but the texture is much better than I expected.
Installation can only be done by removing the original Filler cap, so it can be done in 10 seconds. Rather it may take more time to get the item out of the box ... lol

I have replace SKF fork seal for my CB400sf and it much better than the OEM. With it low friction design the fork move smoothly and even though it still remain good sealed from dust from outside and oil leak from inside. Highly recommended. Best

Every time I replace Motorcycle, I am doing it.
Oil cap around the Engine is also Black this time, I replaced it for Gold though it was one point
Every time it leaves it on the trade-in car and leaves it at hand only increases Normal oilCap (Lol)

Installation and so on are easy task of changing from Normal cap to Gold (Lol)
After all Gold is shining in black

First of all, the Size of the Fork attachment site is thinner than Fork, even if it can not be fixed, I thought whether it could be used if it were to be scraped off, but since it interferes partially with Brake hose, processing is necessary also on the Brake hose side.
As it is not a part that makes the effort to that extent, I gave up the installation, I can not trust Made in China again.
If Bikers' Fork Stabilizer sees product images, I think that interference with Brake hose seems to be avoidable.

cbr1000 only because its conformity is different but it is nice because I bought it for almost half price!.NORMAL same etc. Because the coefficient of friction was good, we chose a paddle sweat exchange.The effect is the same, but the feel is harder than NORMAL, and when it is strongly applied, the sound is also "Snap" ...

It is used for VFR 800 RC 46-2.
I am doing Fit to such an extent as an OEM.
Due to the thinness of the material, it is unknown what the durability is like.
So far, I am satisfied..

Helmet, Wear is multiplied by Mirror, but the attached Wire is useful.
As a burglarproof we are upset if Mirror is removed
There is a sense of security for fall prevention when leaving a bit.

I thought that it could be cheap at with Magnet, purchased, nothing was Paint on the exterior It was good at Simple
Since the tightening Torque is stated in the OEM, I watched it and installed it, but the next time I need to look it up
MT07 was 15 Nm

yeah i though , i bought the long version, instead they sent me the sort version.. the material is solid , the price is affordable.. , in general i like it.

I used this for CB 750 RC 42, Lever liked Black. It used to be a Korea made BlackLever, but I like it because it is glossy here. It is Exactly to RC 42 and there is no astringentness The operation feeling is very good

'