The development of this product began with a single word:"Temp meter stay" by Bagus!. The theme of this Oil Temperature GaugeBracket is to be able to be installed in the center of the Bagus! The oil temperature display should be visible!
Under such a concept, YOSHIMURAProgress1 and Progress2 are completed! Product Contents were also reduced to the minimum and the reduction in cost was also successful!
In addition, in response to your requests, the old YOSHIMURAMulti-temp meter is now also available! This product is for old products and will be sold in Limited Quantity, so please purchase as soon as possible if you wish to have it..
This Temp meter stay easy to read and display as Refreshing. Please try it!
It's definitely better to have a full view!
The development of this product began with a single word:"Temp meter stay" by Bagus!. The theme of this Oil Temperature GaugeBracket is to be able to be installed in the center of the Bagus! The oil temperature display should be visible!
Under such a concept, YOSHIMURAProgress1 and Progress2 are completed! Product Contents were also reduced to the minimum and the reduction in cost was also successful!
In addition, in response to your requests, the old YOSHIMURAMulti-temp meter is now also available! This product is for old products and will be sold in Limited Quantity, so please purchase as soon as possible if you wish to have it..
This Temp meter stay easy to read and display as Refreshing. Please try it!
Peringatan
*Loosen the bolts on the stay body to install the meter. A 2mm hexagonal wrench is required for assembly. (For M3 cap bolt) *M8 collars and 30mm bolts are included for installation, but they are general-purpose products. If the length of the included parts does not fit your vehicle, please change the length of the collars and bolts to fit your vehicle. *This kit is developed based on the "Bagus! Offset Stem Kit" for the handle clamp center. The pitch of the handle clamp of the "Bagus! If you are using a non-Bagus stem kit, please refer to the following table. *The image may include other products. *Please note that the product specification may change due to manufacturer reasons.
*Loosen the bolts on the stay body to install the meter. A 2mm hexagonal wrench is required for assembly. (For M3 cap bolt) *M8 collars and 30mm bolts are included for installation, but they are general-purpose products. If the length of the included parts does not fit your vehicle, please change the length of the collars and bolts to fit your vehicle. *This kit is developed based on the "Bagus! Offset Stem Kit" for the handle clamp center. The pitch of the handle clamp of the "Bagus! If you are using a non-Bagus stem kit, please refer to the following table. *The image may include other products. *Please note that the product specification may change due to manufacturer reasons.
