- Beranda
- Ulasan Produk
- Sparepart Motor
- Sparepart Stang & Kemudi
- Sistem Kendali
- Mur / Baut Komstir
- Saat memasang bilah SX3 pada WR250X dengan penje... (ZETA: Stem Cap)
【ZETA】Stem Cap Review
When installing the SX3 bar on the WR250X with the Y's Gear OEM clamp, it will interfere.
Just the other day I installed zeta sx bars and MX415 on my 2007 WR250X using Y's Gear OEM Taper BarClamp.
No matter which ZETA sxBar clamp you choose, both the rkClamp and RK2Clamp kit are 8mm taller for the rk and 10mm taller for the RK2.
We want OEM height, so Y's Gear (This is Handlebar clamp of 2006 YZ250F) I chose the
But here's the problem, if you build the SX3 bar at OEM height, the Stem Nut Cap and Handlebar will hit each other.
If you don't reduce the thickness by 1.5mm, the Stem Nut Cap will be in the way and the Handlebar will not fit on the Quantity:Cannot Set.
So I shaved the thickness of the circumference Edge of Reverse side of Stem Nut Cap.
Well, apart from that, it's a task that takes about 5 minutes to complete with Leutor, but I was a little saddened to see how poorly designed it is for a ZETA product.
But I'm glad that I was able to put it on without any problems with a little processing.
I liked this Stem Nut Cap so much.
Saat memasang bilah SX3 pada WR250X dengan penjepit OEM Gear Y, itu akan mengganggu.
Beberapa hari yang lalu saya menginstal zeta sx bar dan MX415 pada WR250X 2007 saya menggunakan Y's Gear OEM Taper BarClamp.
Apa pun penjepit ZETA sxBar yang Anda pilih, baik kit rkClamp dan RK2Clamp 8mm lebih tinggi untuk rk dan 10mm lebih tinggi untuk RK2.
Kami ingin tinggi OEM, jadi Y's Gear (Ini adalah klem Handlebar tahun 2006 YZ250F) saya memilih
Tapi inilah masalahnya, jika Anda membuat bilah SX3 pada ketinggian OEM, Stem Nut Cap dan Handlebar akan saling bertabrakan.
Jika Anda tidak mengurangi ketebalan 1,5 mm, Stem Nut Cap akan menghalangi dan Handlebar tidak akan muat di Quantity:Cannot Set.
Jadi saya mencukur ketebalan lingkar Edge of Reverse side dari Stem Nut Cap.
Selain itu, ini adalah tugas yang membutuhkan waktu sekitar 5 menit untuk diselesaikan dengan Leutor, tapi saya sedikit sedih melihat betapa buruknya desain untuk produk ZETA.
Tapi saya senang bisa memakainya tanpa masalah dengan sedikit pemrosesan.
Saya sangat menyukai Stem Nut Cap ini.