- Beranda
- Ulasan Produk
- Sparepart Motor
- Knalpot
- Heat Guard Knalpot
- Saya memproses dan menginstalnya.... (DRC: Exhaust Pipe Guard 4-Cycles)
【DRC】Exhaust Pipe Guard 4-Cycles Review
I processed and installed it.
I machined and attached it to the BEAMS front pipe.
The standard Guard melted the hem of the Pants.
Since it is a commuter main, I decided to float it from the pipe to increase the effect as Heat Guard.
Do not use the supplied band, use the screw holes on the Exhaust Guard that comes with the front pipe.
I used the holes in PipeGuard as they are on the front side and drilled holes in PipeGuard to secure the rear side.
The front side is gradually bent at an angle to match the curve of the exhaust pipe and the rear side remains straight.
The Guard is all floating from the Pipe.
I've run it on the road and it doesn't seem to have any problems with vibration.
Saya memproses dan menginstalnya.
Saya mengerjakan dan memasangnya ke pipa depan BEAMS.
Penjaga standar melelehkan ujung Celana.
Karena ini adalah komuter utama, saya memutuskan untuk mengapungkannya dari pipa untuk meningkatkan efeknya sebagai Heat Guard.
Jangan gunakan band yang disediakan, gunakan lubang sekrup pada Exhaust Guard yang disertakan dengan pipa depan.
Saya menggunakan lubang di PipeGuard karena ada di sisi depan dan mengebor lubang di PipeGuard untuk mengamankan sisi belakang.
Sisi depan secara bertahap ditekuk pada sudut agar sesuai dengan lekukan pipa knalpot dan sisi belakang tetap lurus.
Penjaga semuanya mengambang dari Pipa.
Saya sudah menjalankannya di jalan dan sepertinya tidak ada masalah dengan getaran.