- Beranda
- Ulasan Produk
- Sparepart Motor
- Bodywork
- Bracket Box
- Keberadaan yang berharga... (DAYTONA: Multi Wing Carrier)
【DAYTONA】Multi Wing Carrier Review
Sesuai: HONDA CB1300SUPER BOLD'OR SP, HONDA CB1300SUPER FOUR SP, HONDA CB1300SB, HONDA CB1300SUPER BOLDOR, HONDA CB1300SUPER BOLDOR, HONDA CB1300SF, HONDA CB1300 SF, HONDA CB1300 SF
Precious existence
CB1300ST is a little special MODEL (For us) There,
It seems to be a precious existence in the absence of moderately conforming Parts.
This item, the installation itself can also be attached P.
As our usage, I want to install the 35 L Top case that was attached to NC,
This item is HondaOEMTop caseBase (For DIO 110, LEAD)
I installed it and diverted it.
There were four holes in Base, but the Screw diameter is different
(Screw diameter attached to base is thicker) , So it's open to Carrier
I cut it with Drill to make the hole diameter thick.
The front has an interval of Screw width and it is installed only by widening the hole,
For the rear, I mounted the place where I cut the meat off.
After trying on it, I got a lot of fairly good, passed Bracket
I did not attach it securely.
Please refer to Blue ○ in the image.
CBSeries of the current MODEL, as OEMOption to the previous SB
Top case was also prepared, so it was envious.
Those who are installing MODEL here until you process them like this
I do not think we will come but for your information.
Keberadaan yang berharga
CB1300ST sedikit MODEL Spesial (Bagi kami) Ada,
Tampaknya menjadi keberadaan yang berharga tanpa adanya Bagian yang cukup sesuai.
Item ini, instalasi itu sendiri juga dapat dilampirkan P.
Seperti penggunaan kami, saya ingin memasang casing Top 35 L yang terpasang ke NC,
Item ini adalah HondaOEMTop caseBase (Untuk DIO 110, LEAD)
Saya menginstalnya dan mengalihkannya.
Ada empat lubang di Basis, tetapi diameter Sekrupnya berbeda
(Diameter sekrup yang menempel pada alas lebih tebal), Jadi terbuka untuk Carrier
Saya memotongnya dengan Bor untuk membuat diameter lubang menjadi tebal.
Bagian depan memiliki interval lebar Sekrup dan dipasang hanya dengan memperlebar lubang,
Untuk bagian belakang, saya memasang tempat saya memotong daging.
Setelah mencobanya, saya mendapat banyak yang cukup bagus, lulus Bracket
Saya tidak memasangnya dengan aman.
Silakan lihat Biru pada gambar.
CBSeries dari MODEL saat ini, sebagai OEMOption ke SB sebelumnya
Kasing atas juga disiapkan, jadi iri.
Yang install MODEL disini sampe di proses seperti ini
Saya tidak berpikir kami akan datang tetapi untuk informasi Anda.