- Beranda
- Ulasan Produk
- Sparepart Motor
- Knalpot
- Heat Guard Knalpot
- Saya berkeliling Limit... (DAYTONA: Silencer Heat Guard)
【DAYTONA】Silencer Heat Guard Review
Sesuai: HONDA CBR400R (2013-), HONDA 400X, HONDA CB400F (2013-), HONDA CBR400R (2013-), HONDA NM4-01, HONDA CB500F, HONDA CB500X, HONDA CBR500R, HONDA CB500F, HONDA CB500X, HONDA CBR500R
I went around Limit
KTM 690EDROEMSilencer ○ Because it is a shape close to a rhombus rather than a shape, I was worried that the length of honest Stainless Steel Band is enough, but Limit managed to circumvent it.
As it is truly Limit, it is impossible for one person to install this car.
Furthermore, it is the most difficult to install scratch prevention Band inside the Stainless Steel Band (Stainless Steel Band is short) So I can burn it so I stuck the Stainless Steel Band Double - sided Tape on the back, pasted the Scratch Prevention Band in the Stainless Steel Band before worked.
Since it is very difficult to retighten the Guard Body after wearing the Guard once, it is easier for the person who wore the Bolt after tightening the Bolt after confirming the position of the accessory part after positioning to the Silencer first.
Double-sided Tape of the picture is not an accessory part, so you need to purchase it separately.
Applications are Silencer heat guard - Side Back Although it is burning prevention, I think that it will prevent scratches on Silencer when falling over the mountain even if you are wearing it on a regular basis.
Material is lightweight because it is Aluminum, but the point of contact with Silencer is Small, so there is a possibility that Silencer will pierce when it falls to a flashy.
Saya berkeliling Limit
KTM 690EDROEMSilencer Karena bentuknya yang lebih dekat dengan belah ketupat daripada bentuk, saya khawatir bahwa panjang Tali Stainless Steel yang jujur cukup, tetapi Limit berhasil menghindarinya.
Karena benar-benar Limit, tidak mungkin satu orang memasang mobil ini.
Selain itu, yang paling sulit untuk memasang Pita pencegah goresan di dalam Pita Stainless Steel (Tali Stainless Steel pendek) Jadi saya bisa membakarnya jadi saya menempelkan Pita Dua Sisi Pita Stainless Steel di bagian belakang, menempelkan Pita Pencegah Gores di Band Stainless Steel sebelum bekerja.
Karena sangat sulit untuk mengencangkan kembali Guard Body setelah memakai Guard sekali, lebih mudah bagi orang yang memakai Bolt setelah mengencangkan Bolt setelah memastikan posisi bagian aksesori setelah memposisikan ke Silencer terlebih dahulu.
Pita dua sisi gambar bukan merupakan bagian aksesori, jadi Anda harus membelinya secara terpisah.
Aplikasi Peredam panas pelindung - Sisi Belakang Meskipun ini adalah pencegahan terbakar, saya pikir itu akan mencegah goresan pada Peredam saat jatuh di atas gunung bahkan jika Anda memakainya secara teratur.
Bahannya ringan karena Alumunium, namun titik kontak dengan Silencer Kecil, sehingga ada kemungkinan Silencer akan tertusuk jika jatuh secara menyolok.