- Beranda
- Ulasan Produk
- Sparepart Motor
- Knalpot
- Gasket Knalpot
- Gasket Knalpot
- Saya menggunakannya di ADDRESS V50 CA42A saya.... (NTB: Gasket)
【NTB】Gasket Review
Sesuai: HONDA ZOOMER, HONDA BENLY (BENLY50), HONDA BENLY (BENLY50), HONDA BENLY PRO (BENLY50PRO), HONDA crea SCOOPY (SCOOPY CREA), HONDA crea SCOOPY (SCOOPY CREA), HONDA crea SCOOPY (SCOOPY CREA), HONDA crea SCOOPY (SCOOPY CREA), HONDA crea SCOOPY (SCOOPY CREA), HONDA crea SCOOPY (SCOOPY CREA), HONDA crea SCOOPY(SCOOPY CREA), HONDA crea SCOOPY(SCOOPY CREA), HONDA crea SCOOPY i (SCOOPY CREA i), HONDA crea SCOOPY i (SCOOPY CREA i), HONDA crea SCOOPY i (SCOOPY CREA i), HONDA crea SCOOPY i Special (SCOOPY CREA i SPECIAL Knife), HONDA crea SCOOPY・Special (SCOOPY CREA SPECIAL Knife), HONDA crea SCOOPY・Special (SCOOPY CREA SPECIAL Knife), HONDA crea SCOOPY・Special (SCOOPY CREA SPECIAL Knife), HONDA crea SCOOPY・Special (SCOOPY CREA SPECIAL Knife),
I used it on my ADDRESS V50 CA42A.
After more than 10 years of use, the OEM exhaust system had a hole in it and had to be replaced. At that time, we used this Gasket. I could have reused the old Gasket, but I replaced it with this new Gasket just to be safe because the hole shape of the new Exhaust System is slightly different from the old one. First, the old Gasket was pried off from the body using a slotted screwdriver. I think it is possible to put the Gasket around the hole on the Exhaust System side and press it from the bottom, but there is a groove on the Body side to fit the Gasket. However, there is a groove on the Body side where the Gasket fits, so I think it is safer to fix the Gasket on the Body side with Liquid Gasket. I think it is better to use a Torque wrench that can measure from 5 to 25 Nm.
Saya menggunakannya di ADDRESS V50 CA42A saya.
Setelah lebih dari 10 tahun digunakan, sistem pembuangan OEM berlubang dan harus diganti. Saat itu, kami menggunakan Gasket ini. Saya bisa saja menggunakan kembali Gasket yang lama, tetapi saya menggantinya dengan Gasket yang baru ini hanya untuk amannya karena bentuk lubang Exhaust System yang baru sedikit berbeda dengan yang lama. Pertama, Gasket lama dicopot dari badannya menggunakan obeng berlubang. Saya pikir itu mungkin untuk meletakkan Gasket di sekitar lubang di sisi Sistem Pembuangan dan menekannya dari bawah, tetapi ada lekukan di sisi Bodi agar pas dengan Gasket. Namun, ada lekukan di sisi Bodi tempat Gasket terpasang, jadi menurut saya lebih aman memasang Gasket di sisi Bodi dengan Gasket Cair. Saya pikir lebih baik menggunakan kunci momen yang dapat mengukur dari 5 hingga 25 Nm.
Lihat aslinya