- Beranda
- Ulasan Produk
- Perkakas
- Perkakas
- Obeng
- Obeng Plus
- Kompatibel dengan Handlebar Weightetc. sekrup... (KTC: Soft Screwdriver Cross)
【KTC】Soft Screwdriver Cross Review
Compatible with Handlebar Weightetc. screws
Purchased because I had an inaccurate +Driver at home and had almost licked the Screw when servicing it.
[How is it used?
Screws with Handlebar Weight installed and screws of OEM Exhaust Cover of MONKEY50 are now supported.
Was the one you received as per Image?
The one I received looked as high quality as the picture and had a thin coating of rust-proof Oil on the tip.
How was your experience with it?
It seems to fit very well in the hand, and the grip is very firm, so it will be easy to put on and off the Screw.
However, since the grips are too tight, it is better to use a little more force when using it on a part that should not be tightened too much.
[Points to note]
Be careful not to over-tighten when using this product in areas where tightening Torque is not very high.
How did it compare to other products?
Compared to T-drivers made by other manufacturers, the accuracy, ease of use, and fit are far superior.
Also, my personal impression is that the Plus and Minus Screwdriver Sets are sold separately, but perhaps
I don't think I'll be able to use all of them, so as far as drivers are concerned, I only buy what I need from Single Item sellers.
I think it would be a good idea to do so.
Kompatibel dengan Handlebar Weightetc. sekrup
Dibeli karena saya memiliki +Driver yang tidak akurat di rumah dan hampir menjilat Sekrup saat menyervisnya.
[Bagaimana cara menggunakannya?
Sekrup dengan Berat Setang terpasang dan sekrup Penutup Knalpot OEM MONKEY50 sekarang didukung.
Apakah yang Anda terima sesuai Gambar?
Yang saya terima tampak berkualitas tinggi seperti gambar dan memiliki lapisan tipis Minyak anti karat di ujungnya.
Bagaimana pengalaman Anda dengannya?
Tampaknya sangat pas di tangan, dan pegangannya sangat kuat, sehingga mudah untuk memasang dan melepas Sekrup.
Namun, karena pegangannya terlalu kencang, lebih baik menggunakan sedikit tenaga saat menggunakannya pada bagian yang tidak boleh terlalu dikencangkan.
[Poin yang perlu diperhatikan]
Berhati-hatilah untuk tidak terlalu mengencangkan saat menggunakan produk ini di area di mana Torsi pengencangan tidak terlalu tinggi.
Bagaimana perbandingannya dengan produk lain?
Dibandingkan dengan T-driver buatan pabrikan lain, keakuratan, kemudahan penggunaan, dan kesesuaiannya jauh lebih unggul.
Juga, kesan pribadi saya adalah bahwa Set Obeng Plus dan Minus dijual terpisah, tapi mungkin
Saya rasa saya tidak akan bisa menggunakan semuanya, sejauh menyangkut driver, saya hanya membeli apa yang saya butuhkan dari penjual Single Item.
Saya pikir itu akan menjadi ide yang baik untuk melakukannya.