- Beranda
- Ulasan Produk
- Sparepart Motor
- Rantai / Gear
- Sparepart Skutik
- Sparepart Skutik
- Weight Roller
- VINOsa-26j... (KN Planning: Weight Roller 5.0g)
【KN Planning】Weight Roller 5.0g Review
Sesuai: YAMAHA BWS(BWS), YAMAHA BWS(BWS), YAMAHA JOG (both FI Vehicles), YAMAHA VINO, YAMAHA VINO(2Cycle), YAMAHA VINO(2Cycle), YAMAHA Box, YAMAHA Old JOG (27V|48F|1HHH|1KX|1RN), YAMAHA Old JOG system (2EX|2TA|2TE|2JA|3CP), YAMAHA BJ, YAMAHA JOG-EX, YAMAHA AXIS 50, YAMAHA AXIS 90, YAMAHA APRIO, YAMAHA GEAR, YAMAHA GEAR, YAMAHA JOG, YAMAHA JOG (2Cycle), YAMAHA JOG 80, YAMAHA JOG90,
VINOsa-26j
I installed it in VINOsa-26j07.
The Scooter was given to me by a friend, but it was very dirty and the engine was not running.
After removing the six screws from the case, clean the inside of the case, remove the primary and clean it with an air gun, add NORMAL 5g and Weight Roller Grease, and insert the roller in the correct direction for installation! (Some say that Scooter now does not apply Grease to the Weight Roller.)
Primary tightened with 30Nm. (If it is over-tightened, the KRAN will be ruined, and if it is not tight enough, it will come off while driving.)
Also, don't forget the direction of travel for Belt!
VINOsa-26j
Saya menginstalnya di VINOsa-26j07.
Skuter itu diberikan kepada saya oleh seorang teman, tetapi sangat kotor dan mesinnya tidak menyala.
Setelah melepas keenam sekrup dari casing, bersihkan bagian dalam casing, lepas primer dan bersihkan dengan pistol udara, tambahkan NORMAL 5g dan Weight Roller Grease, dan masukkan roller ke arah yang benar untuk pemasangan! (Ada yang mengatakan bahwa Scooter sekarang tidak menerapkan Grease ke Weight Roller.)
Primer diperketat dengan 30Nm. (Jika terlalu kencang, KRAN akan rusak, dan jika kurang kencang, akan lepas saat mengemudi.)
Selain itu, jangan lupakan arah perjalanan untuk Belt!