It is easy to disconnect the Rubber hose part from the Body.

Since it is undesirable to release Blowby gas directly to Large air, this Filter is attached to the end of Breather Hose 650mm 6mm Diameter.
There is a groove at the joint of the rubber hose, and the plating part of the cleaner body fits into the groove, but the body comes off from the joint when running, probably because the groove is shallow.
The Filter was seated inside the Seat Cowl, but it does not appear to be tightly pressed in, so I assume that it was dislodged by vibration.
I wanted the Filter to Catch the discharged Oil, but the Oil was running through the Rear Fender and Sauce to the Swing Arm from where it came off, so I would like to improve the problem.
I keep regretting that I should have used something like K&N's with an integrated Hose mounting, even if it was a little more expensive.

Sangat mudah untuk melepaskan bagian selang Karet dari Tubuh.

Karena tidak diinginkan untuk melepaskan gas Blowby langsung ke udara Besar, Filter ini dipasang di ujung Selang Breather Diameter 650mm 6mm.
Ada lekukan di sambungan selang karet, dan bagian pelapis bodi pembersih masuk ke dalam alur, tetapi bodi terlepas dari sambungan saat berjalan, mungkin karena alurnya dangkal.
Filter ditempatkan di dalam Seat Cowl, tetapi tampaknya tidak ditekan dengan kuat, jadi saya berasumsi bahwa itu terlepas karena getaran.
Saya ingin Filter Menangkap Oli yang habis, tetapi Oli mengalir melalui Fender Belakang dan Saus ke Lengan Ayun dari tempat asalnya, jadi saya ingin memperbaiki masalahnya.
Saya terus menyesali bahwa saya seharusnya menggunakan sesuatu seperti K&N dengan pemasangan Selang terintegrasi, meskipun harganya sedikit lebih mahal.