It is used for ZX-11 Oil cooler on CB1000SF.

25 years ago, the water-cooling oil cooler of a deoran car was put on, but it was not good enough, and because of the recent high temperature, I made a successful bid for the oil cooler for ZX-11 at Yahoo! ActiveBanjoAD was purchased in order to install the oil hose to this. The problem was that the screw specification of the hole cap of BanjoAD and PLTO did not match, so the UNF9/16 that meets the BanjoAD was substituted with the hose connector for the hydraulic machine. In addition, the female screw end face of this connector is flat, so the taper was cut and screwed in with a drill. By this process, the amount of screwing in can be increased by 1.5 turns and it became difficult to leak. Before this work, I tried hydraulic Elbow without BanjoAD, but it was difficult to handle oil leak and hose, so I gave it up.

Digunakan untuk ZX-11 Oil cooler pada CB1000SF.

25 tahun yang lalu, pendingin oli pendingin air mobil deoran dipasang, tetapi itu tidak cukup baik, dan karena suhu tinggi baru-baru ini, saya berhasil menawar pendingin oli untuk ZX-11 di Yahoo! ActiveBanjoAD dibeli untuk memasang selang oli ini. Permasalahannya spesifikasi ulir tutup lubang BanjoAD dan PLTO tidak sesuai, sehingga UNF9/16 yang memenuhi BanjoAD diganti dengan konektor selang untuk mesin hidrolik. Selain itu, permukaan ujung sekrup perempuan konektor ini rata, sehingga lancip dipotong dan disekrup dengan bor. Dengan proses ini, jumlah sekrup dapat ditingkatkan sebesar 1,5 putaran dan menjadi sulit untuk bocor. Sebelum pekerjaan ini, saya mencoba Siku hidrolik tanpa BanjoAD, tetapi sulit untuk menangani kebocoran oli dan selang, jadi saya menyerah.