- Beranda
- Ulasan Produk
- Sparepart Motor
- Suspensi / Rearset / Velg / Swingarm
- Sparepart Velg
- As Roda
- saya merasa puas... (JB POWER (BITO R&D): Hollow Chromoly Shaft)
【JB POWER (BITO R&D)】Hollow Chromoly Shaft Review
Sesuai: SUZUKI gsx1100s katana (sword)
I feel satisfied
It's quite noticeable as well as visibly satisfying
The sagging sensation at the corner might be gone. I think it is more stable than before and it bends straight
This may be a slow corner speed ride, so it may be the Brush-bo effect (*・ω・) (*-ω-) (*・ω・) (*-ω-)
The price is less expensive than other Shop stuff, so I'm happy with the cost effectiveness
Replacement is as simple as pulling the OEM and plugging it in, no swing arm escapes It is necessary to hold it down as you would like, but it won't be a problem because the correction will work even if it is off
Naturally, you need to float the rear wheels in the STAND and the Tire's floating Tire to prevent the Tire from escaping If you insert a piece of board underneath, it will be harder to escape
You will have the opportunity to perform a GreaseUp on the pivot bearing during the work process Be careful not to guillotine your finger
Because the thickness of Plating is not known, Rust and Hardness are not known to Silicon You might want to do sprayMaintenance when you notice it
Unicorn says that the Shaft should be inserted from the Left, looking backwards, so that the rainwater can get in There is, but they say it's better to change the direction of stabbing from Right to Stab
The Frame is not flat because of weld distortion I painted Packing
saya merasa puas
Ini cukup terlihat dan juga memuaskan
Sensasi kendur di tikungan mungkin sudah hilang. Saya pikir itu lebih stabil dari sebelumnya dan membungkuk lurus
Ini mungkin kecepatan tikungan yang lambat, jadi mungkin efek Brush-bo (*・ω・) (*-ω-) (*・ω・) (*-ω-)
Harganya lebih murah daripada barang Toko lainnya, jadi saya senang dengan efektivitas biayanya
Penggantian semudah menarik OEM dan mencolokkannya, tidak ada lengan ayun yang terlepas. Anda perlu menahannya seperti yang Anda inginkan, tetapi itu tidak akan menjadi masalah karena koreksi akan berfungsi bahkan jika dimatikan
Secara alami, Anda perlu mengapungkan roda belakang di STAND dan Ban mengambang di Ban untuk mencegah Ban keluar. Jika Anda memasukkan papan di bawahnya, akan lebih sulit untuk melepaskannya.
Anda akan memiliki kesempatan untuk melakukan GreaseUp pada bantalan poros selama proses kerja Berhati-hatilah untuk tidak memotong jari Anda
Karena ketebalan Plating tidak diketahui, Karat dan Kekerasan tidak diketahui Silicon Anda mungkin ingin melakukan perawatan semprot saat Anda menyadarinya
Unicorn mengatakan bahwa Poros harus dimasukkan dari Kiri, melihat ke belakang, agar air hujan bisa masuk Ada, tetapi mereka mengatakan lebih baik mengubah arah tusukan dari Kanan ke Tusuk
Bingkai tidak rata karena distorsi las yang saya cat Packing