License Plate Light is required separately

I replaced Kawasaki SUPER SHERPA's Tail lamp with this Lamp. Rearreshing around Rear makes it feel good. However, the protrusion of the installation Bolt was too long, and it was hard to cut.
Wiringetc. I had prepared a service manual, but I could easily do it just by reading the contents in the attached Instruction Manual. However, since there is no function of License Plate Light, we installed the LED License Plate Lamp of AsianMotors at the same time. Although there was a structure which can not exchange Lamp with other people's review, was it a lot difference that I bought? Lamp exchange was possible because Lens can be removed if 4 Screws are relaxed. I will try to replace it with an LED bulb in the meantime. ☆ If it was a bit cheaper ☆ 5.

Lampu Plat Nomor diperlukan secara terpisah

Lampu Belakang Kawasaki SUPER SHERPA saya ganti dengan Lampu ini. Rearreshing di sekitar Belakang membuatnya terasa enak. Namun, tonjolan baut pemasangan terlalu panjang, dan sulit untuk dipotong.
Pengkabelan dll. Saya telah menyiapkan manual servis, tetapi saya dapat melakukannya dengan mudah hanya dengan membaca isi Instruksi Manual terlampir. Namun, karena Lampu Plat Nomor tidak berfungsi, kami memasang Lampu Plat Nomor LED AsianMotors secara bersamaan. Meskipun ada struktur yang tidak dapat menukar Lamp dengan review orang lain, apakah banyak perbedaan yang saya beli? Pertukaran lampu dimungkinkan karena Lensa dapat dilepas jika 4 Sekrup dilonggarkan. Saya akan mencoba untuk menggantinya dengan bohlam LED sementara itu. Jika sedikit lebih murah 5.