- Beranda
- Ulasan Produk
- Sparepart Motor
- Bodywork
- Spakbor
- Fender Eliminator
- Bagi mereka yang bisa kreatif dan cerdik... (LighTech: Adjustable License Plate Holder)
【LighTech】Adjustable License Plate Holder Review
For those who can be creative and ingenious
I purchased this product to install on a 2022 GSX-S1000.
The design is great, but...
As I said, it is different from domestic parts.
First of all, this product cannot be installed by itself; for JapanNumber, three Bolts longer than the supplied Bolt by 5mm or more were required.
There is a bracket for installing an OEMBlinker, but it could not be installed without expanding the mounting holes with a file. This is probably due to the fact that the holes are slightly smaller and the paint on the bracket makes the holes smaller. It is not enough to re-drill the holes by Drilletc.
The wiring of the License light is also short and cannot be connected without an extension. The wiring is so thin that a Crimper for Thin Wire was necessary.
The product itself has only four O-rings for mounting on the vehicle body, and the blinker cannot use the vibration-absorbing rubber of the OEMB blinker, but is directly attached to the vehicle. This structure probably cannot withstand long-term use.
I wanted the License light to be lineup as Repair Parts.
Because of the shortcomings listed above, I thought it was for those who can be creative.
Bagi mereka yang bisa kreatif dan cerdik
Saya membeli produk ini untuk dipasang di GSX-S1000 2022.
Desainnya bagus, tapi...
Seperti yang saya katakan, ini berbeda dari bagian rumah tangga.
Pertama-tama, produk ini tidak dapat dipasang sendiri; untuk JapanNumber, diperlukan tiga Baut yang lebih panjang dari Baut yang disediakan sebesar 5 mm atau lebih.
Ada braket untuk memasang OEMBlinker, tetapi tidak dapat dipasang tanpa memperluas lubang pemasangan dengan file. Ini mungkin karena lubangnya sedikit lebih kecil dan cat pada braket membuat lubangnya lebih kecil. Tidaklah cukup hanya mengebor ulang lubang dengan Drilletc.
Kabel lampu Lisensi juga pendek dan tidak dapat dihubungkan tanpa ekstensi. Kabelnya sangat tipis sehingga diperlukan Crimper untuk Thin Wire.
Produk itu sendiri hanya memiliki empat cincin-O untuk dipasang di badan kendaraan, dan tanda bahayanya tidak dapat menggunakan karet penyerap getaran dari lampu tanda OEMB, tetapi langsung dipasang ke kendaraan. Struktur ini mungkin tidak dapat menahan penggunaan jangka panjang.
Saya ingin lampu Lisensi berbaris sebagai Suku Cadang Perbaikan.
Karena kekurangan yang tertera di atas, saya pikir itu untuk yang bisa berkreasi.