- Beranda
- Ulasan Produk
- Sparepart Motor
- Bodywork
- Spakbor
- Spakbor Belakang
- Pengurangan kotoran di sekitar suspensi belakang... (Puig: Extended Fender (Rear))
【Puig】Extended Fender (Rear) Review
Reduction of dirt around the rear suspension caused by mud splashes
I saw that an acquaintance of mine had installed it on his Racer 9GT, and it seemed to reduce dirt around the rear suspension caused by mud splashes, so I installed it on my MT-09 as well.
The installation structure is simple, using Strong Double-sided Tape and Push rivet, but it was a little time-consuming to remove the Rear Fender.
After removing the tape, wash the adhesive surface well, degrease it with parts cleaner, and apply the double-sided tape, but it was difficult to apply the tape as shown in the Instruction Manual.
After that, we attached the OEMFender and drilled holes with a 4mm drill. However, we thought that if we drilled all four holes on the One Side as described in the instruction manual, it would be easy for the holes to come off.
After installation, I went for a touring trip of about 400 km, including expressways, and it seems to be firmly fixed without any wobble.
Since the OEMFender is extremely short and the area around the Rear suspension is difficult to clean, I thought this Extend Fender was very effective, but I also thought the price was quite high.
I feel that the amount of platters is not much different from the Front side, so I can't deny that it is more expensive than the Front side.
Quantity:If you buy them at Set, the price tag may be a little less expensive because it looks like how much it costs for two.
Pengurangan kotoran di sekitar suspensi belakang akibat cipratan lumpur
Saya melihat ada kenalan saya yang memasangnya di Racer 9GT miliknya, dan sepertinya mengurangi kotoran di sekitar suspensi belakang akibat cipratan lumpur, jadi saya pasang juga di MT-09 saya.
Struktur pemasangannya sederhana, menggunakan Strong Double-sided Tape dan Push rivet, namun agak memakan waktu untuk melepas Rear Fender.
Setelah melepas selotip, cuci permukaan perekat dengan baik, degrease dengan pembersih komponen, dan pasang selotip dua sisi, tetapi sulit untuk memasang selotip seperti yang ditunjukkan dalam Buku Petunjuk.
Setelah itu, kami memasang OEMFender dan mengebor lubang dengan bor 4mm. Namun, kami berpikir bahwa jika kami mengebor keempat lubang di Satu Sisi seperti yang dijelaskan dalam buku petunjuk, lubang akan mudah lepas.
Setelah pemasangan, saya melakukan perjalanan touring sekitar 400 km, termasuk jalan tol, dan sepertinya sudah kokoh tanpa goyangan.
Karena OEMFender sangat pendek dan area di sekitar suspensi belakang sulit dibersihkan, saya pikir Extend Fender ini sangat efektif, tetapi saya juga berpikir harganya cukup tinggi.
Saya rasa jumlah piringnya tidak jauh berbeda dengan Front side, jadi tidak bisa dipungkiri harganya lebih mahal dari Front side.
Jumlah: Jika Anda membelinya di Set, label harganya mungkin sedikit lebih murah karena terlihat seperti berapa harganya untuk dua orang.