- Beranda
- Ulasan Produk
- Sparepart Motor
- Bodywork
- Spakbor
- Fender Eliminator
- Tindakan pencegahan untuk instalasi... (A-TECH: Fender Eliminator Kit)
【A-TECH】Fender Eliminator Kit Review
Precautions for installation
Please keep in mind that not only the A-TECH Fender Eliminator Kit but also most large exterior parts require some modification. Please keep in mind that not only the A-TECH Fender Eliminator Kit, but most large exterior parts require some modification.
Used on Ninja 250R.
The first challenge came with the installation of the BlinkerBush.
The diameter was smaller than the mounting area of the OEMBlinker, so it was difficult to insert the bushing. Grease must be applied. I installed it without grease, but it took a long time.
Then some Gap in Bolt hole.
The bolt included in the kit is smaller in diameter than the OEM bolt, so it can be installed without difficulty.
The third is the attached License Plate Light.
The Bullet Terminal Male was attached, so the OEM License Lamp's Wiring was smashed and installed.
The fourth is the mounting position of the License Plate.
Leutor or Drill is required for this area, so the hole needs to be widened.
Please be aware of the need for these hassles for those who aspire to Carbon.
Tindakan pencegahan untuk instalasi
Harap diingat bahwa tidak hanya A-TECH Fender Eliminator Kit tetapi juga sebagian besar komponen eksterior memerlukan beberapa modifikasi. Harap diingat bahwa tidak hanya Kit Fender Eliminator A-TECH, tetapi sebagian besar komponen eksterior memerlukan beberapa modifikasi.
Digunakan pada Ninja 250R.
Tantangan pertama datang dengan pemasangan BlinkerBush.
Diameternya lebih kecil dari area pemasangan OEMBlinker, sehingga sulit untuk memasukkan busing. Gemuk harus diterapkan. Saya memasangnya tanpa minyak, tetapi butuh waktu lama.
Kemudian beberapa Celah di lubang Baut.
Baut yang disertakan dalam kit berdiameter lebih kecil dari baut OEM, sehingga dapat dipasang tanpa kesulitan.
Yang ketiga adalah Lampu Plat Nomor yang terpasang.
Bullet Terminal Male terpasang, sehingga Kabel Lampu Lisensi OEM dihancurkan dan dipasang.
Yang keempat adalah posisi pemasangan Plat Nomor.
Leutor atau Bor diperlukan untuk area ini, sehingga lubangnya perlu diperlebar.
Harap perhatikan perlunya kerepotan ini bagi mereka yang menginginkan Carbon.